Operation - Hart HGSP02 Manuel D'utilisation

ASSEMBLY
CONNECTING THE SPRAY WAND TO THE
HANDLE
See Figure 2.
 Insert the spray wand into the the handle as shown.
 Slide the o-ring down until it touches the handle.
 Slide the threaded coupling onto the handle and tighten
securely.
 Rotate the nozzle until it is aligned with the handle (point-
ing down) and ready for use.
 Pull on the spray wand to be certain it is properly secured.
 Place the assembled handle into the handle storage area.
ATTACHING THE HOSE
See Figures 3 - 4.
To attach the hose to the tank:
 Slide the nut on the hose away from the hose end.
 Insert the hose end into the hose connector as shown.
Make sure the connection is secure.
 Slide the nut over the opening and hose end. Hand
tighten. Do not overtighten.

OPERATION

WARNING:
Do not allow familiarity with the product to make you
careless. Remember that a careless fraction of a sec-
ond is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields or goggles
marked to comply with ANSI Z87.1 along with breath-
ing protection. Failure to do so could result in fluids
entering your eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use
of attachments or accessories not recommended can
result in serious personal injury.
WARNING:
Use safety equipment. Protect your eyes, skin, and
lungs while mixing, filling, spraying, and cleaning. Fail-
ure to do so may result in serious personal injury and
damage to property.
To attach the hose to the handle:
The hose comes preassembled to the handle. If it becomes
loose, follow the instructions below.
 Install the threaded coupling onto the handle and tighten
securely.
 Slide the nut on the hose away from the hose end.
 Insert the hose end into the opening on the threaded
coupling. Make sure the connection is secure.
 Slide the nut over the hose and threaded coupling. Hand
tighten. Do not overtighten.
NOTICE:
Before each use, inspect the entire product for dam-
aged, missing, or loose parts such as screws, nuts,
bolts, caps, etc. Tighten securely all fasteners and caps
and do not operate this product until all missing or
damaged parts are replaced. Please contact customer
service or an authorized service center for assistance.
APPLICATIONS
You may use this product for the purpose listed below:
 For use with most consumer-grade home-and-garden
chemicals such as insecticides, fungicides, weed killers,
and fertilizers
WARNING:
Improper application of chemicals or solutions can re-
sult in SEVERE INJURY or DEATH. Follow all CDC and
EPA guide l ines. Follow the chemical manufacturer's
safety instructions and guidelines listed on the SDS
sheet.
7 – English