Publicité
Les langues disponibles
Les langues disponibles
•
Remove the opaque while plastic stylus cover from the phonograph stylus by sliding it
in the direction of the arrow.
Discard the stylus cover.
•
Remove the twist-tie that was used to secure the tone arm during shipment.
•
Release the tone arm lock lever.
•
Connect the plug to your AC outlet.
EN
TONE ARM LOCK LEVER
STYLUS COVER
POWER SOURCE
•
This system uses an AC adaptor.
•
You should have your outlet changed by a qualified licensed electrician.
•
In order to make operation run correctly, the power plug and power jack should be a
suitable match.
IMPORTANT: Raising and Lowering the Lid
To open the lid, raise it as far as it will go until the lid support bracket "locks" in the open
position.
To close the lid, lift it upward slightly until the lid support bracket "unlocks", and then gently
lower the lid.
TO AVOID DAMAGING THE CABINET OR THE LID, NEVER FORCE THE LID
EN
TONE ARM LOCK LEVER
STYLUS COVER
Publicité
