Filling The Water Tank - Rowenta IS5100 Mode D'emploi

Fabric brush assembly
Be sure unit is unplugged and completely cool before attaching this
accessory.
• Insert the fabric brush into the holes located on the steam head.
• Before removing the fabric brush, be sure the appliance is unplugged
and totally cool.
• Pull the brush out of the steam head to remove it.
TIP : Before using this accessory, check the manufacturer
recommendations. It is also recommended that you carry out a test on
part of the fabric which cannot be seen.
fig.9

Filling the water tank

IMPORT NT
Never use water that contains additives (starch, perfume, aromatic
substances, softener, etc) in the steamer. dditives such as these can
affect the properties of the steam and lead to the formation of
deposits. Never use water complitely distilled or demineralized.
• Ensure that the steamer is unplugged (fig.11). Remove the water tank
from the base of the appliance by pulling the handle upwards.
Unscrew the tank cap and fill the tank. The tank holds 2.35 liters (80
ounces).
• The steamer must be used with T P W TER. If the water in your area
is hard, Rowenta recommends that you mix half tap water and half
distilled water, which reduces the hardness. You can also use bottled
spring water.
• fter closing the cap, turn the tank down and hold it by the handle.
Check out that no water is leaking through the cap.
fig.10
20
(fig.9)