PNI B5000 Manuel Utilisateur page 3

EN
Operation:
Connect both the baby unit and the parent unit to the power adapter included in the package or insert 3 AAA alkaline
batteries (batteries are not included in the package).
Push up the on/off key. The green LEDs confirming the device power will light up.
Place the child unit in the child's room at a distance of about 2 m from the child. Parents can hear the child's voice with
the receiver unit. You can adjust the volume using the volume control keys. The volume level LEDs indicate the level of
sound emitted by the child. Parents can talk to the child by pressing the Talk key. Releasing the Talk key, you can hear
your child's voice again.
In extreme cases, such as strong interference, poor signal or complete signal loss, try changing the channel by pressing
the Reset and Pair Device buttons, as shown below. The two units, parent and child, will look for an uninterrupted
channel and will continue to function. (Avoid doing this if the transmission is good)
Press the button inside the hole by a pin if there is interference.
Reset & Pairing:
Typically, the two units are associated from the factory.
This operation is only required if the parent unit (the receiver) loses the signal emitted by the child unit (the transmitter).
1. Turn the two units on, using the power adapter. Press for one second, at the same time, Reset buttons placed in the
battery compartment in both units. Both units are now reset. Immediately after this operation you must proceed with
the pairing of the two units.
2. Press for one second, at the same time, the pairing keys on both devices. When the LEDs that confirm the operation
begin to blink at amble units, it means that the two devices have been paired. Restarts normal operation.
Reset buttons
Battery supply:
1. Use only AAA 1.5V alkaline batteries (6 batteries for both units are required. Batteries are not included in the package.)
2. Remove the battery compartment cover, loosen the screw, and insert the batteries in accordance with the polarity.
3. Put the cover back and close the screw securely.
4. Turn on the device and check that the power LED is on and green.
3