Inakustik NF-A1 Mode D'emploi page 24

Operation
24
NF-A1
Placement
The NF-A1 set consists of two components: the cinch cable with NF-A driver
and the NF-A1 Power Supply.
The NF-A1 driver has two tubes and two class A transistor stages that warm up
during operation. To avoid malfunctions and damage, the NF-A1 driver may not
be covered and must be well ventilated. The same applies naturally also to the
NF-A1 mains adapter (see also Safety instructions).
Connection
1.) Before you connect the black&white NF-A1 Driver as well as the NF-A1
Power Supply, please switch off all components and pull out the mains
plugs.
2.) If your system already has an interconnect cable, please remove it.
3.) Place the Audio Cable with the integrated NF-A1 driver (item 16), between
the respective components. On laying the cable, make sure that it is free
and as far from other cables as possible, to avoid interference and losses in
sound quality. Make sure you observe the direction of the cable run. You
can recognize the direction by the arrows on the cinch plugs and on the
system cable (the system cable is on the output side - see drawing). The
NF-A1 driver must be well ventilated (see also Installation and Safety
instructions)!
4.) Connect the source cinch cable (item 8) to the output socket of your
source device (item 13) and connect the target cinch cable (item 9) to the
target device (item 14). In doing so, observe the left / right channel
coding.
5.) Now place the NF-A1 mains adapter (item 15) in the rack with your
devices. The NF-A1 driver must not be covered and must be ventilated
sufficiently (see also Installation and Safety instructions)!
6.) Now insert the system plug (item 11) of the NF-A1 driver into the system
socket of the NF-A1 mains adapter (item 4). In doing so, observe the
notch in the system socket and the correct position of the system plug.
Under no circumstances should the plug be inserted by force! The system
plug is screwed in tightly with the blue ring in clockwise direction. When
this is done, the system plug is pushed firmly into the system socket.
7.) Plug the enclosed mains cable AC-1502 into the NF-A1 mains adapter (item
8.) Before you connect all components to the mains supply, please first re-
check the entire installation.