Electrical Connection - Resol VBus-Repeater Manuel

Electrical connection

ATTENTION ! ESD damage!
Electrostatic discharge can lead to damage
to electronic components!
Î Take care to discharge properly be-
fore touching the inside of the device.
To do so, touch a grounded surface
such as a radiator or tap!
To connect the VBus cable, proceed as follows:
®
Î To open the housing, unscrew the cover screw and
pull off the upper part of the housing.
Î Connect the included VBus
marked Master with either polarity.
Î Connect the other end of the cable to the controller
VBus terminal.
®
Î Connect the modules to the terminal pairs marked
VBus Devices (1, 2, 3) with either polarity.
®
Î To close the housing again, relocate the upper part of
the housing and refasten the cover screw.
Î Connect the mains adapter to the connection socket
of the VBus Repeater.
®
10
cable to the terminals
®
The VBus cable can be extended to up to 150 m with a
®
two-wire cable (cross section at least 0.5 mm
1
VBus ® Master terminals VBus
).
2
Connection socket for
the mains adapter
2 3
Devices terminals
®