Publicité
User guide
Luxstat wireless control 79-050
Use
The Luxstat wireless control is part of the Luxstat wireless
lighting control system concept.
The Luxstat wireless control, controls the light level wirelessly in
LED luminaires which are equipped with the Servodan wireless
Luminaire control system.
The light level in the LED luminaires can be controlled in relation
to incoming daylight. This may include one or more wireless
movement sensors for the control operation, as well as wireless
pushbuttons for manual operation such as switching on/off and
dimming the lighting.
The Luxstat Cut-off control 1-10 V accessory, type 79-210, also
provides an option for controlling light fi ttings via 1-10 V.
The Luxstat wireless lighting control system is installed locally
in the individual rooms. The system is based on wireless
communication, thereby requiring minimal wiring.
All the wireless pushbuttons are of the same type and do not
require either a voltage supply or batteries.
You can implement the system via an easy-to-use Windows
start-up software application.
You can select various applications using this basic start-up
software:
Use the pushbutton to switch on/off all the lighting manually.
It switches off automatically via the movement sensor.
Use the movement sensor to switch on/off all the lighting
automatically, with the option of switching it on/off manually
and dimming it using the pushbuttons.
Individually switch on/off three lights manually; switch off all
three lights automatically via a movement sensor.
Individually switch on/off three lights manually; each light is
automatically switched off individually via the three movement
sensors installed in the relevant area for each light.
You have the option to choose other applications and change
parameters using the Service start-up software:
Dim the lighting in areas where the movement sensor does
not detect any activity.
You can install the individual application in up to fi ve areas.
Servodan A/S | Tel +45 7442 4726 | Fax + 45 7442 4035 | info@servodan.dk | www.servodan.com
Function
Controlling the Servodan LED daylight luminaires, equipped with
Luminaire Controller, type 79-150.
Example:
Controlling broad-spectrum, dynamic LED lighting.
Switching on/off type 76-926 manually using the wireless pushbut-
ton; automatically switched off via the wireless movement sensor.
With the lighting on and the wireless pushbutton type 76-925 in
position, the lighting will be controlled automatically in relation
to the incoming daylight. As the amount of incoming daylight
increases, the light in the room is dimmed to the specifi ed light
level. If the incoming daylight is adequate in each zone, the
lighting turns off in the relevant zone.
One light sensor controls all three zones.
The light is always switched on via the pushbutton and switches
off automatically after a preset period, when the movement
sensors do not detect movement in the area covered.
You can switch on/off and dim the lighting manually via a
wireless 4-pushbutton, e.g. type 76-925
The LED luminaires can also include coloured LEDs, thereby
providing a broad range of dynamic daylight.
Fitting
Remove the Luxstat wireless control's cover and fi t the unit using
the installation holes.
Refer to the connection diagram on the next page to see how to
connect the unit.
Close the unit by snapping the cover back on.
To remove the cover again, loosen the four "locks" and lift the
cover off.
79Y050_03_R3_090119KOE
79Y050_03_R3_090119KOE
GB
3(8)
Publicité
