Digi Sport Instruments DTM100 Mode D'emploi page 5

PACER MODE
1. Depress D to select the PACER
mode. The display will be as shown
with the last 2 digits at the lower
row blinking.
2. At this status depress B will
sequence the PACER frequency as
follows: 10, 20, 30,40,60,80,
120,160,240,320.
3. Depress A to start PACER. A
beeping sound of 320 beeps/minute will
sound. The total time elapsed will be
shown on the top row, the beep counter
at the centre and PACER frequency at
the lower row. The beep counter has a
range of 9999.
4. Depress A to stop PACER.
Remarks: Pacer will
stopwatch is switched to another mode.
5. Depress D to select CLOCK
mode. The alarm hour, alarm minutes,
month, date, day, year, hour, minute and
seconds are displayed as shown.
6. Time setting can be done by
means of depressing B to select digits
and A to advance digits.
7. Alarm is automatically armed if
alarm hour or minute has been set.
Alarm can also be armed or disarmed by
depressing C at normal time mode.
When alarm is armed 'AL' is flashing.
When the alarm time is reached and the
alarm is armed, an output of 3 short
beeps/second will sound for 15 seconds.
If the alarm time is reached when the
stopwatch is in other modes, the alarm
will only sound 3 short beeps
CARE OF YOUR STOPWATCH:
*WATER RESISTANCE
The stopwatch is designed to withstand
accidental contact with water such as
splashes or raindrops, but it is not
designed for use in water. Do not operate
the buttons when the stopwatch is wet.
and
*TEMPERATURE
Do not leave your stopwatch under direct
sunlight or in very high temperatures for a
long time, the display may become black.
Do not leave your stopwatch in very low
temperature as this may cause a slight
time loss or gain and the change of digits
becomes slow. In both cases the above
be reset if
conditions will be corrected when the
stopwatch returns to normal temperature.
*SHOCKS
Be careful not to drop your stopwatch or
hit it against hard surfaces as it may
cause a mechanical damage.
*STATIC ELECTRICITY
The integrated circuit in your stopwatch
can be affected by static electricity. If the
static
permanent damage can occur. Be careful
of the screen of the TV set and the
wearing of clothing made of synthetic
material in dry weather; in such cases a
very strong static electricity can be
generated.
electricity is very strong
*MAGNETISM
Not affected
*CHEMICALS
Do not expose your stopwatch to
solvents such as gasoline and alcohol,
spray of cosmetics, cleaners, paints
etc as they may cause damage to the
stopwatch.
*BATTERY CHANGE
When the display becomes dim of
faded out, battery replacement is
necessary.
1. Unscrew and remove back cover.
2. Unscrew the battery contact.
3. Replace with fresh lithium battery
CR2032 or equivalent.
4. Before putting in the fresh battery
makes sure that the triangular contact
is in the triangular slot under the
battery.
5. Do not use any small metal tool
(such as a tweezer of screw driver) as
it could momentarily short circuit the
a ACpad at the lower side of the battery.
6. Rescrew the back cover.
THE WARRANTY DOES NOT
COVER THE BATTERY.
Use a battery of quality.