Troubleshooting - Greenlee Quick Draw Manuel D'utilisation

Troubleshooting

Problem
Tool is inoperative.
Tool loses oil.
Failure to retract
Stuck drawstud
Greenlee Tools, Inc.
Quick Draw
Possible Cause
Dirt, contaminants, etc. in ram
area of tool.
Tool components worn or
damaged.
Damaged internal seal.
Pressure valve in closed
position
Over-tightened
Hydraulic Knockout Drivers
®
Probable Remedy
Clean tool.
Return tool to a Greenlee Authorized Service Center.
Return tool to a Greenlee Authorized Service Center.
Open pressure valve.
Bottom tool out (do not apply pressure after ram travel
stops) and use hex key to back drawstud out.
11
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070