Metabo HPT UU 240F Instructions De Sécurité Et Mode D'emploi page 9

INSTALLING THE SAW MOUNTING BRACKETS
(FIG. E)
1. Press the locking button (1) and lift up on the cam
latch (2).
2. Place the rear holding clamp (3) on the back rail of
the stand, and then lower the front end of the saw
mounting bracket over the front rail of the stand.
NOTE: Place the saw mounting brackets on the
interior side of the bracket stoppers.
3. Slide the saw mounting bracket to the desired
position, and then push down the cam latch (2)
to lock.
4. Repeat the above steps for the other saw mounting
bracket.
Fig. E
INSTALLING THE ANCHOR PLATES (FIG. F, G)
Please follow the steps below to install the anchor plates
to make the stand stable for operation.
1. Insert an anchor plate (1) through one stand leg (2)
directly, and fix the anchor plate (1) to the ground
surface with an anchor (screw, bolt, peg etc.) which
is suitable for the type of ground surface (soil, wood
flooring, concrete etc.).
2. Insert the other anchor plate to diagonal stand leg as
shown in Fig. G. Fix the anchor plate to the ground in
the same way.
WARNING
● Ensure that both anchor plates are fixed firmly to the
ground and the stand is stable.
● Appropriate way to fix the anchor plates may differ
according to the type of ground surface. If the anchor
plates are not firmly fixed and the stand is unstable,
please take appropriate measures to fix the anchor
plates.
1
2
3
Fig. F
not included
Fig. G
MOUNTING THE MITER SAW TO THE STAND
● Do not mount the miter saw to the stand without
first ensuring the stand is extended fully and locked
securely. To set up the stand, follow the instruction
in section "SETTING UP THE STAND" on page 13.
Failure to do so may result in possible injury and
damage to the stand and the miter saw.
● Always use the saw mounting brackets and auxiliary
mounting bracket together when mounting the miter
saw to the stand.
● Before operating the mounter miter saw, read
carefully the instruction manual for the miter saw.
Using auxiliary mounting brackets (provided)
(FIG. H, I, J, K)
1. Insert two square nuts (1) into the slot on each end of
both auxiliary mounting brackets (2) and slide them
to the middle of the auxiliary mounting brackets.
(Fig. H)
– 9 –
2
1
WARNING
English