SERVODAN 79-210 Notice D'utilisation page 3

User guide
Luxstat Cut-off control 1-10V 79-210
Use
The Luxstat Cut-off control 1-10V is part of the Luxstat wireless
lighting control system concept.
The Luxstat Wireless Control (79-050) controls the wireless
Luxstat Cut-off control, which controls light fi ttings equipped
with ballast designed for 1-10 V control.
The light in the light fi ttings can be controlled in respect to
incident daylight. One or more movement sensors can be
included in the control as well as wireless pushbuttons for
manual operation such as On/Off and dimming of the lighting.
The Luxstat wireless lighting control system is installed locally
in the individual rooms. The system is based on wireless
communication between operation, movement sensors and the
Luxstat Cut-off control, so wiring is kept to a minimum.
Light fi ttings are connected to 230 V and to 1-10 V directly on
the Luxstat Cut-off control.
All the wireless pushbuttons are of the same type and do not
require either a voltage supply or batteries.
You can implement the system via an easy-to-use Windows
start-up software application.
You can select various applications using this basic start-up
software:

Use the pushbutton to switch on/off all the lighting manually.
It switches off automatically via the movement sensor.

Use the movement sensor to switch on/off all the lighting
automatically, with the option of switching it on/off manually
and dimming it using the pushbuttons.

Individually switch on/off three lights manually; switch off all
three lights automatically via a movement sensor.

Individually switch on/off three lights manually; each light
is automatically switched off individually via the three
movement sensors installed in the relevant area for each
light.
You have the option to choose other applications and change
parameters using the Service start-up software:

Dim the lighting in areas where the movement sensor does
not detect any activity.

You can install the individual application in up to fi ve areas.
Servodan A/S | Tel +45 7442 4726 | Fax + 45 7442 4035 | info@servodan.dk | www.servodan.com
Function
Example:
Control of light fi ttings equipped with 1-10 V ballast
Switching on/off type 76-926 manually using the wireless push-
button; automatically switched off via the wireless movement sensor.
With the lighting on and the wireless pushbutton type 76-925 in
automatic mode, the lighting will be controlled in relation to the
incident daylight. As the amount of incident daylight increases,
the light in the room is dimmed to the specifi ed light level. If the
incident daylight is adequate in each zone, the lighting turns off
in the relevant zone. One light sensor controls all three zones.
The light is always switched on via the pushbutton and switches
off automatically after a preset period, when the movement
sensors do not detect movement in the area covered.
You can switch on/off and dim the lighting manually via a
wireless 4-pushbutton, e.g. type 76-925.
For optimal operation and energy saving, at least one Luxstat
Cut-off control should be placed in each zone/area.
Fitting
Remove the Luxstat Cut-off control's cover and fi t the unit using
the installation holes.
Refer to the connection diagram on the next page to see how to
connect the unit.
Close the unit by "snapping" the cover back on.To remove the
cover again, loosen the four "locks" and lift the cover off.
79Y210_03_R1_090219KOE 79Y210_03_R1_090219KOE
GB
3(8)