Publicité
Les langues disponibles
Les langues disponibles
FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
7
5
This towbar is designed to assembly in following cars:
FORD FOCUS II 4 doors (Mk2) produced since 05.2005 till 02.2011,
catalogue number C48A and is prepared to tow trailers max total weight
1500 kg and max vertical load 75 kg.
From manufacturer
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and correct
exploitation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
5
7
1
3
The instruction of the assembly
1. Disassemble bumper and metal reinforcement of the
bumper (reinforcement will not be used any more).
2. Slip main bar of the towbar (pos. 1) in this way so holes of
towbar agree with holes in chassis members and fix it
using bolts M10x35mm (pos. 5), use big washers pos. 7 as
shown on the figure.
3. Reassemble the bumper.
4. Fix body of the automat (pos. 6) and the socket plate (pos.
3) using bolts M12x25mm (pos. 4) from accessories. Place
tow-ball (pos. 2) according to supplied instruction.
5. Connect electric wires according to the instruction of the
car. (Recommend to make at authorized service station)
6. Complete the paint coating damaged during installation.
Torque settings for nuts and bolts (8,8):
M 8
25 Nm
M 12 85 Nm
After install the towbar you should get adequate note in
registration book (at authorised service station).The car should be
equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must
be always kept clear and conserve with a grease.
M 10 55 Nm
M 14 135 Nm
NOTE
Publicité
