Publicité
Les langues disponibles
Les langues disponibles
Speedaire
®
Operating Instructions and Parts Manual
Speedaire
Maintenance
Always
shut off
air pressure at source and
bleed off all pressure in paint
tank by gently pulling safety
valve ring before loosening knobs to
remove lid.
E
CLEANING
N
G
IMPORTANT: It is very important that
L
the tank material hose and spray gun be
I
cleaned as soon as the spray job is
S
completed.
H
1. Shut off air tank at air pressure
regulator by turning adjusting screw
counterclockwise.
2. Gently pull safety valve ring to purge
air from tank.
3. Completely cover spray gun nozzle
with a soft rag and with air lines
pressurized, pull trigger of the gun.
This will force paint remaining in the
material hose back into the tank.
4. Remove tank lid and pour any
remaining paint back into original
containers for future use.
5. Using a clean, dry cloth, wipe inside
area of tank clean.
Troubleshooting Chart
Symptom
No material coming
from tank
Air leak at tank lid
Paint Tank
®
which contain trichloroethane,
chlorinated hydrocarbons,
nitrohydrocarbons, esters, amines, or
organic compounds. These materials will
damage the gasket between the paint
tank and lid. A damaged gasket may
cause injury and will reduce the efficiency
of the paint tank.
6. Pour about 1/2 gallon of paint solvent
into the tank. Use the correct type of
solvent for the paint being used:
mineral spirits for oil base paint,
lacquer thinner for lacquer base
paints, warm soap water for Latex,
etc.
7. Clamp lid onto tank and proceed to
spray the proper solvent through
spray gun and hose.
8. Following steps 1 through 9 in this
section, remove all thinner from hose.
9. Clean lip of tank groove of paint tank
lid and gasket.
Possible Cause(s)
1. Plugged hoses or material tube
2. Damaged regulator diaphragm
3. Incorrect hose connections
1. Damaged gasket
2. Dirty tank rim
3. Eyebolt knobs not tightened securely
Never use this paint
CLEANING THE SAFETY VALVE
tank with materials
Remove the safety valve and clean port
(orifice) periodically. Accumulations of
paint in the port can prevent proper
valve action. Do not disassemble valve or
change settings.
calibrated and sealed. Do not attempt to
disassemble safety valve or alter
calibration.
ROUTINE
Periodically inspect the tank for leaks
around the paint tank lid. If leakage
occurs, remove the pint tank lid and
clean lip of tank and groove in tank lid.
Replace gasket.
Corrective Action
1. Check hoses and material tube
2. Check regulator for leaks. Replace diaphragm if
necessary
3. Check connections according to instructions
1. Replace gasket
2. Clean rim
3. Check tightness (See Operation)
Purge all air from tank before
adjusting eyebolt clamps
4
1ZMG5
This component has
been factory
Publicité
