Publicité
Les langues disponibles
Les langues disponibles
Speedaire
®
Operating Instructions and Parts Manual
Model 1ZMG5
Operation
1. Before using the tank for the first
time, the seal and bracket position
should be established by pre-
pressurizing the tank.
a. Connect the material hose to the
spray gun.
b. Connect the air hose from
regulator to the spray gun or cap.
c. Before filling the tank with paint
material, evenly tighten the knobs
so that the lid is secure and sealed.
d. Close the paint tank regulator by
turning fully counterclockwise,
then open the air regulator on the
source to deliver air to the paint
tank regulator.
e. Increase paint tank pressure by
turning the knob clockwise until
30 psi reads on the tank regulator
gauge.
Material
hose
Paint tank
regulator
Bracket
Figure 4
f. Check for leaks in the system. If a
fitting leaks, depressurize the tank
by shutting off the air at the air
source regulator and gently pulling
the ring on the paint tank safety
valve until air no longer hisses from
it. Tighten the leaking fitting, then
open the air source regulator to
deliver 30 psi into the paint tank
and material hose.
g. Depressurize system by shutting off
air supply, then gently pull the
relief valve ring to relieve the
pressure in the system.
2. The tank may now be filled with
material. Before filling, thoroughly
mix and strain the paint to remove
skins or undissolved particles which
might otherwise impede the flow of
material through the hose and gun. A
one gallon can of paint can be set
inside the tank instead of pouring the
paint into the tank.
Air hose
Air source
regulator
Air hose
3
Never use this paint
tank with materials
which contain trichloroethane, chlorinated
hydrocarbons, nitrohydrocarbons, esters,
amines, or organic compounds. These
materials will damage the gasket between
the paint tank and lid. A damaged gasket
may cause injury and will reduce the
efficiency of the paint tank.
3. Place lid on paint tank then tighten
knobs evenly and gradually.
DO NOT USE WRENCH OR PLIERS TO
TIGHTEN KNOBS. HAND TIGHTEN
ONLY (50 IN.LBS.)
4. Turn pressure off at the air source
regulator by turning
counterclockwise. Pressure gauge
should read 0 psi.
5. Shut off paint tank regulator by
running counterclockwise.
SPRAY GUN OPERATION
1. Adjust air source regulator pressure
required for spraying (usually
between 50-70 psi).
2. Adjust paint tank regulator to 25-30
psi. More pressure is needed on the
material as the gun is moved further
above the tank. Normal operating on
the paint tank is 25 to 30 psi. When
lower pressure is needed, rotate the
adjustment counterclockwise until the
desired pressure setting is obtained.
There is no need to trigger the gun in
order to bleed off excess paint
pressure.
Do not use over 50
psi in the tank.
The sprayer may now be used to apply
paint.
E
N
G
L
I
S
H
Publicité
