Use - Nutri Ninja BL480DC Manuel Du Propriétaire

Use

WARNING: Handle the Pro Extractor Blades
WARNING: NEVER leave the appliance unattended while in use.
WARNING: Remove utensils prior to processing. Failure to remove may cause the
shatter, which may cause personal injury.
CAUTION: DO NOT blend hot liquids,
the user being burned.
CAUTION: Remove the Pro Extractor Blades Assembly from the cup upon completion of blending.
NOT store ingredients before or after blending in the Nutri Ninja
Some foods may contain active ingredients or release gases
resulting in excessive pressure buildup that can pose a risk of injury.
use only Sip & Seal
™
IMPORTANT: Make sure the motor base is plugged in for use.
ASSEMBLY
Fig. 1 Fig. 2
1
Review warning and caution statements above before
proceeding to step 2.
2
Place the motor base on a clean, dry, level surface such
as a counter or tabletop.
3
Make sure the motor base is plugged in for use. Display
will read "--".
4 Add ingredients to the Nutri Ninja Cup.
NOTE: DO NOT overfill! To avoid spilling,
ingredients past the "MAX" fill line.
5
Place the Pro Extractor Blades Assembly onto the cup
and twist it on clockwise
(Fig. 1)
6
Turn the cup upside down and place it onto the motor
base, aligning the tabs on the cup with the motor base.
Turn it clockwise, until you feel it click into place. The
Timer light will illuminate.(Fig. 2)
7 Press one of the buttons to activate. (Fig. 3)
NOTE: When using the Auto-iQ
operate using pulses, pauses, and continuous runs. The
pauses allow the contents of the cup to settle. When
the timer reaches "0" it will stop by itself.
™
as doing so may cause excessive pressure buildup, resulting in risk of
Lid to cover.
USE
Fig. 3
DO NOT
until you have a tight seal.
presets, the unit will
®
Assembly with care, as the blades are sharp.
Cup
®
that will expand if left in a sealed container,
Fig. 4
8 To remove the cup,
running. Then turn the cup
and pull straight up to remove. (Fig. 5)
9 Turn the cup upright and remove the Pro Extractor
Blades Assembly by twisting the
(Fig. 6)
10 DO NOT
store blended contents with the Pro Extractor
Blades Assembly attached.
add
11 Twist the Sip & Seal
on the go. Press
to get the best seal. The
pressed backward.
12 For ingredient storage in the
Lid to cover.
13 Be sure to store the Pro Extractor Blades Assembly
attached to an empty cup when not in use.
14 Make sure the motor base is unplugged when not in
use.
15
To release motor base from counter or tabletop, place
your hands underneath both sides of the motor base
and gently pull the unit up and toward you.
cup to be damaged or to
with the blade assembly attached.
For ingredient storage in the cup,
REMOVAL
Fig. 5
ensure the motor has stopped
counterclockwise
it counterclockwise.
Lid onto the cup to enjoy your drink
flip-top cap firmly into the opening
flip-top cap locks open when
cup, use only
ninjakitchen.com
DO
Fig. 6
(Fig. 4)
Sip & Seal
10