Installing Sidebrush; Using Dust Cloths - V.Bot P4960 Mode D'emploi

INSTALLING SIDE BRUSH
1. Unscrew and remove the brush holder on the bottom of the unit by
turning counter clockwise as shown in the following diagram
2. Place the brush on the brush mount and then put the brush holder back
by turning clockwise
3. Bristles should extend from the center of the brush like the rise of
the Sun.
.

USING DUST CLOTHS

1. Insert the edge of the micro fiber dust cloth into the grip slots on the dust
cloth holder.
2. Press the dust cloth holder onto the base of the vacuum as shown below
until it clicks into place.
Micro fiber dust cloth
Brush Holder
Grip Slot
Dust cloth holder
8
Side brush
Dust cloth holder
clicks into place