Cleaning Intake; Cleaning Side Brushes - V.Bot P4960 Mode D'emploi

CLEANING AND MAINTENANCE

Cleaning Intake

After repeated use, dirt and dust can
accumulate around the intake of the
vacuum and the working efficiency can
be reduced. To ensure the best perfor-
mance and constant air flow, the intake
should be cleaned periodically.
1. Turn the power to the OFF posi-
tion and place the vacuum upside
down on a flat surface such as the
floor or a table.
2. Wipe and remove any hair or other
material that may accumulate
around the intake.

Cleaning Side Brushes

1. Turn off the power, place bottom of the cleaner upward on a flat surface.
2. Rotate and take off the brush lid and side brush and then clean up the hair
or other matters by hand.(See diagram below)
3. Install back the lid and brush after finishing.
4. After being used for a period of time, the brush need to be replaced to
clean more effectively.
5. The side brush can be rinsed and if they become crooked, you can scald
them in hot water to make them return to original shape.
12
Intake