NUTRIBULLET Juicer Pro Manuel D'utilisation page 4

Assembly & use.
1. Motor Base
Place the
dry, level counter top Ensure
the dial is set to the
position and the unit is
unplugged.
2. Place the Pulp Basin
the Motor Base. Align the
Basin
with the Motor Base so
that the spout is aligned with
the dimpled side of the Motor
Base.
3. Align the Sieve with the motor
drive coupling and push down
until it clicks into place. Handle
Sieve
the by gripping the top
edges being careful not touch
the sharp teeth on the base of
the Sieve. Ensure the
properly seated in place and
securely inside of the Pulp
Basin.
4. Basin Cover
Place the
the Sieve and Pulp Basin. The
side "ears" on the
should align with the "ears" on
the sides of the Pulp Basin.
5. Raise the Locking Handle
move it into the "ears" on each
side of the Basin Cover. The
Locking Handle should be in a
vertical position and locked into
place.
NOTE: if the Locking Handle
is not securely in place, the
juicer will not power on.
6. Swing the No-Drip Spout
cover up vertically so that it is
no longer covering the juice
spout.
7. Place the Juice Pitcher Lid
top of the Juice Pitcher, and
open the locking lid latch.
8. Slightly angle the Juice Pitcher
and place it under the juice
spout. Align the spout with the
hole in the Juice Pitcher Lid
and level out the Juice
It will fit snuggly into the spout
to hold it in place.
6
Usage instructions.
on a 1. Gather all of your desired
ingredients. Wash and prepare
"OFF"
them for juicing.
2. After the juicer is fully
assembled, plug the power cord
on top of
into an outlet.
Pulp
NOTE: If no speed is selected
after 10 minutes, the unit will
power off.
3. Select a speed to begin
juicing. The speed selected
will illuminate on the control
Sieve is
panel. You may start at
any speed and can toggle
between speeds as desired
depending on the type of
produce (refer to the chart
over on page 8 for recommended
speeds for each type of
Basin Cover
produce).
NOTE: always start the juicer
before putting food in the feed
chute.
and
4. To operate the
Pusher, grip the outer edge of
the top of the pusher with one
hand and the bottom of the
pusher with the other hand.
Twist the top of the pusher
clockwise to unlock the inner
pusher. (The inner pusher is
thinner than the full pusher.)
5.
If you are using smaller
ingredients (smaller fruits, leafy
greens, stalk vegetables like
celery or carrots), place the
outer part of the pusher into
on
the chute, making the chute
more narrow. While the motor
is running, begin gently guiding
ingredients into the internal
chute using the inner pusher.
Pitcher.
TIP:
When using the narrow chute for juicing
leafy greens, take a small handful of greens
and squeeze them into a tighter bunch. Place
the bunch into the chute and slowly push
down into the Sieve. Using the narrow chute
will help to prevent any pieces from flying up
out of the chute.
6. If you are using larger
ingredients, keep the feed
chute empty (creating a wider
chute) and lock the inner
pusher back inside the outer
pusher. While the motor is
running, begin gently guiding
your ingredients into the feed
chute using the full
Food Pusher.
NOTE: You may alternate between the two chute
sizes (narrow and wide) as you are juicing.
WARNING: Do not use excess force when pushing
food down with the
for maximum juice yield.
WARNING: Never use hands/fingers or other tools to
push ingredients down the feed chute into the Sieve.
Only the Food Pusher
ingredients.
7. Juice will begin to flow out of
the spout and into the
Pitcher, while the pulp will be
separated and stored in the
Pulp
8. When the
completely full, it must be
emptied before continuing
juicing. See disassembly
instructions.
Dual-Size Food
9. To stop juicing, press the speed
at which you are currently
juicing. To completely power
off the juicer, press the center
power button and wait for the
Sieve
the unit after each use.
10. Remove the Juice Pitcher from
NOTE:
need to tip the Juice Pitcher
forward at a slight angle, so that
the lid's large hole has some
separation from the spout, then
you can slide out the pitcher.
This is the reverse of what you
did during assembly.
11. Immediately move the No-Drip
Spout cover downward over the
spout to avoid any residual drips
onto the unit or onto the surface
below the juicer.
TIP: We recommend using your left hand to pull
the Juice Pitcher
hand to swing the
and over the spout opening.
Dual-Size
Control panel.
MULTI-SPEED CONTROL PANEL
& JUICING SETTINGS.
Food Pusher, as it will not allow
should be used to push down
Juice
Basin.
Pulp Basin is
to stop spinning. Unplug
under the spout. You may
close the Juice Pitcher Lid and
store juice in the Juice Pitcher if
desired.
To do this, you'll first
away, while using your right
No-Drip Spout cover down
OFF:
Power is OFF. If the unit is ON,
the center power button will be
illuminated. Pressing the center
button will turn the unit OFF.
LOW:
Best for juicing softer fruits
and vegetables.
HIGH:
Best for harder produce
like pineapples.
TURBO:
Best for juicing the toughest
vegetables like beets or carrots.
7