Publicité
Les langues disponibles
Les langues disponibles
Initial operation
Connect the provided mains cable to the mains connector at the back of the device and connect
the Schuko plug to an earthed mains socket.
Swich on the device with the power switch (POWER I/0).
After a short initialisation phase the device is ready for operation.
Connect the corresponding measuring lines/probes to the BNC connectors. The connector
„OUTPUT 50 Ω" delivers the generated voltage with an impedance of 50 ohm.
An external signal can be fed to the connector „COUNTER INPUT" for frequency measuring.
The measuring voltage should only be impressed on the internal conductor. The
external conductor (reference earth) is connected to the earth potential (protec-
tive earth conductor).
The indicated maximum measuring voltage must not be exceeded due to safety
reasons.
Remove the probe from the object after finishing the measuring, and turn off the appliance.
Cleaning
Always observe the following safety instructions before cleaning the device:
Live components may be exposed if covers are opened or parts are removed
(unless this can be done without tools).
Prior to cleaning or repairing the device, all lines have to be detached and the
device has to be turned off.
Do not use scouring, chemical or aggressive cleaning agents such as benzine, alcohol or the like.
These might attack the surface of the device. The fumes are furthermore a health hazard and are
explosive. Moreover, you should not use sharp-edged tools, screwdrivers or metal brushes or
similar for cleaning.
For cleaning the device or the display and the measuring lines, use a clean, fuzz-free, antistatic
slightly damp cloth.
Should questions occur concerning the handling of the device, feel free to con-
tact our technical support under the following phone number:
Conrad Electronic SE, Klaus-Conrad-Str. 2, 92530 Wernberg,
Phone 0180 / 531 211 8
Disposal
Electronic products are a raw material and do not belong in household waste. When
the device has reached the end of its service life, dispose of it in accordance with the
current statutory regulations at the communal collection points.
Disposal in the domestic waste is not permitted.
You thus fulfil the legal requirements and make your contribution to the protection of the envi-
ronment!
These operating instructions are published by Conrad Electronic SE,
Klaus-Conrad-Straße 1, D-92240 Hirschau/Germany.
The operating instructions reflect the current technical specifications at time of
print. We reserve the right to change the technical or physical specifications.
© Copyright 2007 by Conrad Electronic SE. Printed in Germany.
Publicité
