Publicité
Les langues disponibles
Les langues disponibles
FITTING INSTRUCTION
Clamp mark
in acc. with
ISO
PN
1
L
2
+
8
3
31
4
R
6
5
58R
6
54
7
58L
7
B
9
A
3
This towbar is designed to assembly in following car:
OPEL COMBO (B
), passenger car, delivery truck,
till 02.2002, catalogue number E20A and is prepared to tow trailers max
total weight 1200 kg and max vertical load 50 kg.
Thank you for buying our product. Their reliability has been confirmed in many
tests. Reliability of towbar depends also on correct assembly and right operation. For this
reasons we kindly ask to read carefully this instruction and apply to hints.
The towbar should be install in points described by a car producer.
Cables joining
Left directional lights
Rear fog lights
Ground
Right directional lights
Right side parking lights
Stoplights
Left side parking lights
Löcher O 22 mm
ø22mm
1
6
5
A
produced since 08.1995
From manufacturer
1. To install this towbar disassemble the spare wheel and take out the floor
finish.
2. On the left and right side of the trunk find per three original marked
points, next drill per two outmost holes on each side using bit ø11mm
(through chassis members also)
3. Using bit ø22mm enlarge holes only from trunk side (in upper part of
9
8
chassis members).
4. To made holes (pos. B) put distance sleeves (pos. 7) and put fish-plates
6
6
(pos. 6) and insert bolts M10x90mm (pos. 8).
5. Underneath the car on protruding bolts put side brackets (pos. 4 and 5)
7
7
and fix loosely.
6. Between installed brackets put main bar of the towbar (pos. 1) and fix
by holes (pos. A) using bolts M12x35mm (pos. 9) from towbar
accessories.
8
7. Fix body of the automat and place tow-ball according to supplied
instruction. Note! Remember to place socket plate (pos. 3) as shown on
the drawing 1.
8. Fix tight all bolts according to the torque shown in the table.
7
9. Connect electric wires of 7-poles socket according to the instruction of
the car. (Recommend to make at authorized service station)
10. Complete paint layer damaged during installation.
B
9
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar must be
always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm
M 10 - 55 Nm
M 12 - 85 Nm
M 14 - 135 Nm
NOTE
Publicité
