Windsor Zephyr Mode D'emploi page 4

New & Reconditioned Equipment & Parts- www.southeasternequipment.net
1 Steam pistol
2 Handwheel for steam control
3 Release button
4 Locking mechanism (child lock)
5 Steam switch
6 Modular accessory plug
7 Reset button – Descaling completed
8 VAPOHYDRO control knob
9 Temperature indicator
10 Steam control knob
11 Indicator light – Descaling due (white)
12 Indicator lamp –
Low water warning, additional tank (red)
13 Indicator lamp – Heater (yellow)
14 Heater ON/OFF switch
15 Steam supply switch
16 Indicator lamp –
Low water warning, boiler (red)
17 Boiler cap with safety valve
18 Tank cap
19 Funnel for filling tank
20 Extension tubes
21 Spot nozzle
22 Circular brush
23 Extension
24 Power nozzle (red)
25 Hand nozzle
26 Terry-toweling slip-on
27 Window nozzle*
28 Floor nozzle
29 Large wiping cloth
30 Household iron *
31 Temperature control
32 Steam-ironing switch
33 Indicator lamp – heater for household iron
34 Retaining bracket
35 Floor Nozzle Storage Fitment
* Optional accessory
1.1 Unpacking the unit
• If you notice any transport damage while
unpacking the unit, please report it to your dealer
immediately.
• The packaging materials should not simply be
disposed of as domestic refuse. Instead, the left-
over packaging components should be taken to
an official collection point for recycling.
4
English
New & Reconditioned Equipment - www.southeasternequipment.net
1. Starting the unit
1.2 Attaching the accessories
• Connect the modular accessory plug to the main
unit. The lugs on the plug must lock into place on
the cover of the main unit socket.
• Attach the required accessory (floor, hand or spot
nozzle) to the steam gun. Push both parts
together until the lock button on the steam gun
snaps into place.
• If required, use the extension tubes. Assemble the
tube sections by pushing one into the other until
the button snaps into place.
• Press the release button to separate the acces-
sories from each other.
1.3 Filling the boiler with water
• Remove the safety cap from the main unit.
• Using the funnel, pour a maximum of 0.5 gal (2
litres) of tap water into the boiler. Hot water
shortens the heating-up time.
Note: With the unit standing on a level surface, the
boiler can be filled up to 0.75 in (2 cm) below the top
of the filler neck.
• Do not use any detergents.
• Refit the safety cap onto the main unit, and ensure
that it is properly tightened.
Additional tank
Fill the additional tank in order to prolong the time
that the cleaner can be used before it requires
refilling.
• Unscrew the cap on the additional tank.
• Using the funnel, pour a maximum of 0.5 gal (2
litres) of tap water into the tank.
• Screw the cap back onto the tank.