FITTING INSTRUCTION
B
8
1
16
3
2
7
This towing hitch is designed to assembly in following car:
MERCEDES VANEO produced since 2002, catalogue no. D27
and is prepared to tow trailers max total weight 1200 kg and max vertical
load 50 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer.
Clamp mark
in acc. with
ISO
PN
1
L
Left directional lights
5
2
+
Rear fog lights
3
31
Ground
9
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
4
9
4
8
From manufacturer
1. Take the spare wheel out the bumper
Cables joining
2. Unscrew the plastic covers at the bottom of the car
3. Slide the distance sleeves L=62mm (pos. 5) to the original
holes, then position the bar of towing hitch (pos. 1) (do it in
such a way that holes pos. A cover holes of the distance
sleeves) and fix it using M10x100mm (pos. 9).
4. Put the bolts M12x35mm (pos. 8) through the holes (pos. B)
and fix it with the chassis member
5. Position the ball of towing hitch (pos. 2) with socket plate
A
(pos. 3) and fix with M12x75mm (pos. 7) bolts from the
towing hitch accessories.
6. Tighten all nuts and bolts according to the torque shown in
the table
7. Connect the electric wires according to the instructions of the
car
B
8. Complete the paint cover of towing hitch (during the
mounting paint cover could be destroyed)
After install the towing hitch you should get adequate note in registration
book (at authorised service station).The car should be equipped with:
• Indicators
• Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must be
always kept clear and conserve with a grease.
Fitting instructions
Torque settings for nuts and bolts (8,8):
M 8
25 Nm
M 10 55 Nm
M 12 85 Nm
M 14 135
NOTE
Nm