Publicité
Les langues disponibles
Les langues disponibles
EN
Electrical and mechanical specifications :
dimensions and weight : 88 x 127 x 58 mm – 0,3 Kg
mains : 230Vac +/- 10%
operating temperature range : from 0 to + 60 °c
lamps power supply : 230Vac / 1000 W max.
Timer programming : from 1 to 250 seconds
operating frequency : 433,92 mHz
radio receiver rF sensitivity : approx. -102 dBm
Caution : The unit must be not switched on if the connected loads or the power supply exceed the a.m. limits. Failure
to observe this instruction may cause damage or injury to persons, animals or objects for which the manufacturer can
not be held liable.
Electric connections:
il existe 2 connecteurs sur la carte électroniques
a) J1 : Pole Terminal Board for the connection of the devices operating with 230Vac (mains cable and lamps)
b) J2 : Pole Terminal Board for the connection of the devices operating at low voltage (commands and antenna)
TERMINAL BOARD J1
Terminal1 - 230 Vac mains (phase)
Terminal2 - 230 Vac mains (neutral)
Warning: The power supply voltage polarities must be carefully observed.
Terminal3 - 230Vac lamps power supply (common)
Terminal4 - 230Vac lamp 1 power supply
Terminal5 - 230Vac lamp 2 power supply
TERMINAL BOARD J2
Terminal1 – lamp 1 start button (n.o. contact)
Terminal2 – lamp 2 start button (n.o. contact)
Terminal3 – common terminal for all start buttons
Terminal4 – antenna input (signal)
Terminal5 – antenna input (shield)
Connection of the devices
230Vac mains – Terminals 1 and 2 on J
Warning: The cable's ground pole must be connected to a good ground reference
in the roller shutter's nearby area.
Lamp 1 – Terminals 3 and 4 on J1
Lamp 2 – Terminals 3 and 5 on J1
Antenna – Terminals 4 and 5 on J2
Lamp 1 start button – Terminals 1 and 3 on J2
Lamp 2 start button – Terminals 2 and 3 on J2
Important: Before starting the device, check all connections to the electronic card.
Check also the electric contacts' switching.
Publicité
