Publicité
Les langues disponibles
Les langues disponibles
conTrol'S UniT
For lamPS ligHTing
230V
cTr29l contains a 2 channels
auto-learning receiver.
You can manage two different
loads that operate with 230Vac
by two relay contacts (10a).
The receiver can memorize
120 different codes which come
from various remote controls.
It's possible to select 2 different ways of operation:
1) Flip-flop: The relay switches on by pressing on the button of remote control and it switches off by pressing on the button again.
Bridge the terminals 1-2 of JP1.
2) Timer: The relay switches on by pressing on the button of remote control and it switches off after the programmed time
(4 minutes maximum).
Bridge the terminals 2-3 of JP1.
Programming :
Auto-learning of codes:
a) Press once on the button P2 to insert a code which manages relay 1.
b) Press twice on the button P2 to insert a code which manages relay 2.
WARNING: Separate at least 1 second the pressure on the button P2 by the following one.
after you carried out one of the two operations, wait for the lighting of led. Then send the code to learn for at least 1 Sec.
on releasing of button the led will turn off to signal that the code has been recognized and memorized. in case of missed
code the led will be lit for 10 Sec., then it will automatically turn off (end of operation).
Erasing all codes :
Press the button P2 until the led will turn off (about 10 seconds).
Timer programming :
a) Press once on the button P1 to insert a work time for relay 1.
b) Press twice on the button P1 to insert a work time for relay 2.
WARNING: Separate at least 1 second the pressure on the button P1 by the following one.
after you carried out one of the two operations, wait for the lighting of led. Pass the desired time, then press again
on the button P1. on releasing of button the led will turn off to signal that the code has been memorized.
V.09-2014 ::: Ind. A
Installation and user manual
cTr29l
EN
Publicité
