AUTO-HAK P23A Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
4
7
7
6
This towbar is designed to assembly in following cars:
CITROEN C5 I Break, Estate (X42) produced since 04.2001 till 09.2004,
catalogue number P23A and is prepared to tow trailers max total weight
1600 kg and max vertical load 85 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
7
1
3
From manufacturer
1. Disassemble the plastic part of the bumper (this part is not
used any more)
5
2. Fix the side brackets (pos. 4 and 5) through the original holes
6
using bolts M10x35mm pos. 7 (do it loosely)
3. Slide the bar of towbar (pos. 1) between fixed side brackets
then fix it using bolts M12x35mm (pos. 6).
4. Tighten all nuts and bolts according to the torque shown in
the table
5. Fix body of the automat and place tow-ball according to
supplied instruction. Note! Remember to place socket plate
(pos. 3) as shown on the drawing.
6. Connect the electric wires according to the instructions of the
car.
7. Complete the paint cover of towbar (during the mounting
paint cover could be destroyed).
2
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar must be
always kept clear and conserve with a grease.
Fitting instructions
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm