AUTO-HAK P22 Instructions De Montage page 4

FITTING INSTRUCTION
5
C
7
B
A
3
4
2
This towbar is designed to assembly in following car:
CITROEN XANTIA 5 doors (X1/X2), produced since 03.1993 till
02.2001, catalogue no. P22 and is prepared to tow trailers max total weight
1600 kg and max vertical load 85 kg.
Thank you for buying our product. Their reliability has been
confirmed in many tests. Reliability of towbar depends also on correct
assembly and right operation. For this reasons we kindly ask to read
carefully this instruction and apply to hints.
The towbar should be install in points described by a car producer.
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
D
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
1
B
5
7
C
6 A
7
From manufacturer
1. Disassemble the bumper.
2. Put main bar of the towbar (pos. 1) to rear part of the car and through existing
holes and holes in the towbar (pos. A and B) fix it using bolts M10x35mm
(pos. 7), use washers (pos. 10) as showed in the fig.1. Fix loosely.
3. Fix elements (pos. 5) through holes (pos. C) using bolts M10x35mm, next
through holes (pos. D) in element (pos. 5) fix to original holes in the car using
bolts M10x35mm and washers (pos. 10) (as showed in the drawing).
D
4. Fix all bolts according to the torque shown in the table.
5. Reassemble the bumper after cut out his fragment in lower part (as shown in
the fig. 2).
6. Fix tow-ball (pos. 2) and socket plate (pos. 3) using bolts M12x75mm (pos. 6)
from accessories.
7
7. Connect electric wires according to the instruction of the car. (Recommend to
make at authorized service station).
Fig.1
8.
Supplement the paint coating damaged during assembly.
M6 - 11 Nm
M 12 - 87 Nm
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar must be
always kept clear and conserve with a grease.
The instruction of the assembly
50
95
Fig. 2. Bumper cut out
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm
M 14 - 138 Nm
NOTE
Original hole
Base hole.
M 10 - 50 Nm
M16 - 210 Nm