AUTO-HAK P10A Instructions De Montage page 4

FITTING INSTRUCTION
10
5
B
C
13
17
14
4
9
A
3
17
11
This towbar is designed to assembly in following cars:
CITROEN XSARA, 3/5 doors (N1), produced since 04.1997 till 03.2005,
catalogue no. P10A and is prepared to tow trailers max total weight 1300
kg and max vertical load 70 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
Clamp mark
in acc. with
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
7
4 R Right directional lights
14
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
18
14
8
14
B
9
17
12
From manufacturer
1. Take out the fitted carpet and the spare wheel from boot, disassemble
two plastic plugs from left and right side.
Cables joining
2. Underneath fix upper plate (pos. 7) to the cross beam of the car using
bolts M10x30mm (pos. 14), use big washers ø35xø12x4mm (pos. 17).
3. Fix side handles (pos. 9) using bolts M10x30mm (pos. 14).
4. Fix bottom plate (pos. 8) to the upper plate (pos. 9) using two bolts
M10x30mm (pos. 14).
5. Put main bar of the towbar (pos. 1) to fixed elements (pos. 7, 8 and 9)
and fix it with bolts M10x70mm (pos. 12) and with cylinder head cap
bolt (imbus) M12x70mm (pos. 11), use big washers ø35xø12x4mm
(pos. 17).
10
6. At points A fix left bracket (pos. 4) using bolts M10x30mm (pos. 14).
7. At points B fix jibs (pos. 5 and 6) using bolts M10x40mm (pos. 13) and
big washers ø35xø12x4mm (pos. 17)
C
8. Fix body of the automat and place tow-ball according to supplied
17
instruction. Note! Remember to place socket plate (pos. 3) as shown on
the drawing 1.
9. Fix bolts on the jib (pos. 10) at points C.
6
ATTENTION! After disassemble plastic plugs (see point 1) you will
find holes, through you should put bolts on the jib (pos. 10).
13
10. Tighten all bolts according to the torque shown in the table.
11. Connect electric wires of 7-poles socket according to the instruction of
the car. (Recommend to make at authorized service station).
12. Complete paint layer damaged during installation.
After install the towbar you should get adequate note in registration book
(at authorised service station). The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be always
kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE