Starway ParKolor 200HD Manuel De L'utilisateur page 28

TEMP :
•
Choose temperature unit
FAST DIMMER
Enter this sub-menu to bypass [DIM Mode] in case of rapid channel change from Dimmer to 0.
•
Choose [ON] or [OFF] to change dimmer behavior.
DIM MODE
Enter this sub-menu to set the speed of the Dimmer.
•
Choisir [DIM0] for instant dimmer, [DIM1] for a 0,25 second dimmer speed,
[DIM2] for a 0,5 second dimmer speed, [DIM3] for a 0,75 second dimmer speed,
[DIM4]
or for a 1 second dimmer speed.
DISP.Set :
Enter this sub-menu to define the display mode
•
[ADDR] to display the DMX adress.
•
[Disp.CH] to display the DMX values.
•
[Slave] to switch the PARKOLOR 200 HD to slave mode.
FAN.Set :
Enter this sub-menu to define the cooling mode
•
[Auto]
fans in automatic mode
•
[High] fans in foced operation mode at 100%
•
[Quiet] fans in silent mode
•
[Silent] fans OFF
DIM CURVE
Enter this sub-menu to define the Dimmer curve.
•
[Linear]
- The increase in light intensity is linear as the DMX value increases.
•
[Square] - Light intensity control is finer at low levels and coarser at high levels.
•
[Inv-Square] - Light intensity control is coarser at low levels and finer at high levels.
•
[S-Curve] - Light intensity control is finer at low and high levels and coarser at medium levels.
Linear Curve
DFSE :
•
Enter this sub-menu to reset the device to factory default.
(Reload the values shown in
Page 28
[CELSIUS] or [FAHRENHEIT].
Square Curve
red
in the menu structure)
Inv-Square Curve
S Curve