Wolf E Serie Guide D'installation page 6

INSTALLATION
Preparation
Before moving the oven, protect any finished flooring and
secure oven door(s) closed to prevent damage.
Use an appliance dolly to move the unit near the opening.
Remove and recycle packing materials. Do not lift or carry
the oven by the door handle.
CAUTION
Do not lift oven by the door handle. This will damage
the oven door and hinges.
OVEN DOOR REMOVAL
To lighten the load or to fit through a door way, the oven
door(s) can be removed. Only remove if necessary. Door
removal should only be done by a certified installer or
service technician.
To remove, open the door completely. Rotate both hinge
latches forward to the open position, then lift door up and
out. Refer to the illustration below.
To reinstall, insert door hinges into frame openings, then
rotate hinge latches to the closed position.
CLOSED
OPEN
Oven door removal.
6 | English
Electrical Connection
WARNING
Verify that power is disconnected from the electrical
box before proceeding.
Open the terminal box to expose the screws with corre-
sponding numbers. Run the cord through the strain relief
hole and into the terminal box.
For Single Phase Install (Line, Neutral, Ground): Loosen
the 1, 5, and ground screws. Attach the Neutral wire to the
number 5 position. Line should be attached to the 1 position
and attach the ground to the corresponding ground screw.
For 3phase Install (L1, L2, L3, Neutral, Ground): Loosen the
1, 2, 3 and remove the copper bars. Loosen 5 and ground
screws. Attach L1 to position 1. L2 to position 2. L3 to posi-
tion 3. Neutral wire to position 5 and attach the ground to
the corresponding ground screw.
After tightening the screws, tighten down the cord strain
relief and close the cover to the terminal box without
pinching any of the wires.
Connection of this appliance should be
IMPORTANT NOTE:
through a fused connection unit or a suitable isolator, which
complies with national and local safety regulations. The
on/off switch should be easily accessible after the appli-
ance has been installed. If the switch is not accessible after
installation (depending on country) an additional means of
disconnection must be provided for all poles of the power
supply. When switched off there must be an all pole contact
gap of 3 mm in the isolator switch. This 3 mm contact dis-
connect gap must apply to any isolator switch, fuses and/or
relays according to EN60335.
WARNING
Copper bars must be removed from positions 1, 2, and
3 when connecting to 3phase power.
˜
3N
˜
L1 L1
L2
L3
N N
Single phase wiring diagram. 3phase wiring diagram.
Installation
Place the oven in the opening and slide back. Verify the
conduit slides through the opening of the base support
and is not trapped between the oven and cabinet wall. The
conduit must fit into the recessed area along the right rear
edge of the oven.
Locate mounting holes on the oven side trim, two on each
side for a single oven and three on each side for a double
oven. Drill pilot holes. Use the wood screws provided to
secure the oven to cabinetry. Refer to the illustration below.
CAUTION
Failure to install the mounting screws may cause the
oven to tip forward during use.
CAUTION
For proper ventilation, do not block the exhaust vent
located at the bottom of the oven.
CONTROL PANEL ALIGNMENT
To adjust alignment, open the oven door and loosen the
two screws under the control panel. Pivot the bottom of the
control panel in or out, then tighten screws. Refer to the
illustration below.
SCREWS
MOUNTING
HOLES
Mounting holes. Control panel alignment.