Publicité
Les langues disponibles
Les langues disponibles
A v o i d i n s t a l l i n g t h i s u n i t i n p l a c e s
exposed to direct sunlight or close to
h e a t r a d i a t i n g a p p l i a n c e s s u c h a s
electric heaters, on top of other stereo
equipment that radiates too much heat,
places lacking ventilation or dusty areas,
places subject to constant vibration and/
or humid or moist areas.
Do not attempt to clean this unit with
chemical solvents as this might damage
the finish. Use a clean dry cloth.
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital
d e v i c e , p u r s u a n t t o P a r t 1 5 o f t h e F C C R u l e s . T h e s e l i m i t s a r e d e s i g n e d t o p r o v i d e
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
r e c e p t i o n , w h i c h c a n b e d e t e r m i n e d b y t u r n i n g t h e e q u i p m e n t o ff a n d o n , t h e u s e r i s
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
IMPORTANT NOTES
O p e r a t e c o n t r o l s a n d s w i t c h e s a s
described in the manual.
Before turning On the power, make
c e r t a i n t h a t p o w e r c o r d i s p r o p e r l y
installed.
Store your phono-records in a cool
area to avoid damage from heat.
When moving the set, be sure to first
disconnect the power cord.
3
,
Publicité
