Publicité
Les langues disponibles
Les langues disponibles
Insatallation
Step 3:
Connect the end of the cable with the DIN connector and audio cables to the back of
the head unit as shown in Fig. . The shorter end of the cable, coming from the PIA, is a
pass-through cable that can be used to connect other products to your head unit, i.e., CD
changer.
Note: The location of the connections on the head unit may vary depending on the model.
Step 4:
Start your car and turn on your head unit to confirm that the XM Direct system is properly
connected. Please refer to your stereo owners manual on how to access XM mode. When
you tune to XM channel 1, you should see "XM Preview" on your head unit LCD, and hear
that channel through your car speakers. If not, check to make sure all connections are
correct or refer to the troubleshooting section of this installation guide.
Step 5:
Mount and secure the interface cable in a suitable location that will not interfere with the
radio and will not vibrate or rattle after installation.
XM Radio
Tuner
Left / Right
DIN Connector
Audio Cables
Fig. Head Unit (Rear View) Connections
3
Publicité
