Publicité
Les langues disponibles
Les langues disponibles
Setup
E
Attaching the Wrist Strap
1.
While facing the front of the tool, insert the thin end
of the wrist strap through one of the holes in the
lower right corner of the tool.
2.
Push the thin end of the wrist strap until it goes
through the other hole.
3.
Separate the two wires, which make up the thin end
of the wrist strap, to form a loop.
4.
Insert the thick end of the wrist strap all the way
through the loop in the thin end, so the wrist strap
is securely fastened to the tool (Figure
Charging the Battery
Fully charge the battery before initial use and whenever
the tool has not been used for 6 months or longer.
1.
Locate the port cover on the side of the tool
(Figure
).
A 4
2.
Using your finger, gently pull the port cover down
(Figure
).
E 1
3.
Insert the small end of the USB Recharge Cable
into the port on the side of the tool, making sure to
insert the flat side of the cable into the flat side of
the port (Figure
4.
Insert the USB end of the cable into a USB port in a
computer or USB power outlet (Figure
5.
Wait approximately 2.5 hours for the battery to
fully charge and then disconnect the USB Recharge
Cable.
When the tool is ON, the battery level appears in the
display window (Figure
4
).
B
).
E 2
E 3
).
D 1
Operation
1.
Point the laser (Figure
whose distance you need to measure (Figure
).
1
2.
Click
display a laser dot on the wall (Figure
3.
When the bottom of the tool is positioned at the
correct distance from the wall, click
measurement (Figure
4.
View the measurement on the display window
(Figure
D 2
Changing the Unit of Measure
Once the current measurement is taken, you can
change the unit of measure from decimal ft (6.21 ft)
to fractional ft (6'02"9/16), fractional ft to meters
(1.894 m), meters to inches (74 9/16 in), or inches to
decimal ft.
To change the unit of measurement, press and hold
until you see the measurement change (2-3 seconds).
NOTE: If you continue to hold
changes, the tool will turn off.
Re-measuring
If you need to take a new measurement, click
• The previous measurement (Figure
cleared from the display window.
).
• When you are ready to take the new measurement,
click
.
Turning Off the Tool
The tool can be turned off in either of these ways:
• After taking a measurement, press and hold
5 seconds (until the display window clears).
• If you do not use the tool for 45 seconds, it will
automatically turn off.
) toward the wall
A 1
(Figure
) to turn the tool on and
A 3
).
C 2
).
after the measurement
D 2
C
).
C 1
to take the
.
) will be
for
Publicité
