Princeton Tec LEAGUE II Notice D'utilisation Et D'entretien

LEAGUE
TM
LED FLASHLIGHT
Operating and Maintenance
Instructions
Notice d'utilisation et d'entretien
Bedienungs- und Wartungsanleitung
www.princetontec.com
ENGLISH
Battery Replacement – See Figure 1
• 3 AA - Alkaline
Princeton Tec cares about the environment
and recommends recycling batteries. For
more information about battery recycling,
please go to www.batteryrecycling.com.
Use with three AA batteries, Duracell: MN1500
To install batteries, loosen the three Phillips
head screws from the tail cap and then
remove the tail cap from the light body.
Install three AA batteries, observing proper
polarity. Improper installation of the batteries
will damage the light and void the warranty.
Finally, align the tail cap and hand tighten
Phillips head screws. Do not over tighten the
screws.
WARNING
C
• Never mix fresh and used batteries
• Never mix different battery brands
• Always remove drained batteries
• Remove batteries during long periods of
storage
O-Ring
Occasionally clean and lightly lubricate the
0-ring. Use only silicone grease, never use
aerosol spray lubricants. Certain types of
aerosol sprays can cause damage the plastic
and void the warranty.
Switch Operation – See Figure 2
League II's switch locks in both on and off
positions. From the off and locked position,
slide the lock forward then move the switch
right to turn the light on. Lock switch by
sliding the lock toward the back of the light
if desired.
Troubleshooting
If the League II fails to light:
• Check batteries the for proper installation.
• Replace batteries if proper installation is
confirmed.
• Check circuit board for water (the seal may
have been compromised by improper rear
cover installation or dirty seal). The light will
resume normal operation once the water
is shaken or blown out and the light is
left open until completely dry. If the light
Figure 1 – Battery Replacement
1
0715
3
II
Figure 2 – Switch Operation
• Princeton Tec calculates total burn time as the time it takes for the light source to produce a minimum of
0.25 lux at 2 meters. 0.25 lux is about the equivalent of a full moon on a clear night.
• Princeton Tec berechnet die Gesamtbrenndauer bezogen auf eine von der Stirnlampe erzeugte minimale
Beleuchtungsstärke von 0,25 Lux in 2 Meter Abstand. 0,25 Lux entsprechen in etwa der Beleuch-
tungsstärke des Vollmonds in einer klaren Nacht.
• Princeton Tec définit la durée totale d'éclairage comme le temps nécessaire à la source
lumineuse pour produire un minimum de 0,25 lux à 2 mètres. 0,25 lux équivaut à peu près à la
luminosité d'une pleine lune dans un ciel nocturne dégagé.
has been contaminated with salt water,
flush the unit with fresh water and dry as
described above.
USA Limited Lifetime Warranty –
International 10-Year Warranty
Due to International regulations, Princeton
Tec's lifetime warranty can only be offered to
customers in the USA. Princeton Tec offers a
10-year warranty to our customers outside
the USA. FULL WARRANTY – Princeton Tec
warrants this product to be free from defects
in workmanship and materials under normal
use for as long as you own this product.This
warranty covers all of the component parts of
the product except batteries. This warranty
does not cover deterioration due to normal
wear or damage due to misuse, alteration,
negligence, accidents, or unauthorized repair.
Princeton Tec will repair or replace parts which
are defective in workmanship or materials.
Your authorized Princeton Tec Dealer and
Princeton Tec are the only facilities authorized
to repair the product. After (3) unsuccessful
attempts to repair the product, you have the
right to elect replacement of the product or a
refund of the purchase price less allowance
for use of the product. NO INCIDENTAL
OR CONSEQUENTIAL
INCLUDED IN THIS WARRANTY. (Some
states do not allow the exclusion or limitation
of incidental or consequential damages, so the
above limitations or exclusions may not apply to
you.) This warranty gives you legal rights, and
you may also have other rights which vary from
state to state.
Princeton Tec reserves the right to change
product specifications without notice.
Remplacement des piles
2
4
5
Opération de commutation
Maxbright
LED
DISTANCE (Meters) 1
Return Policy
If your light fails to operate, follow these
simple steps:
1. Check batteries. Replace if necessary.
2. Contact Princeton Tec customer service
at 800-257-9080 to request an RMA
number to send your light in for repair or
replacement. No warranty repairs will be
accepted without an RMA number.
3. Return the light without batteries to:
Princeton Tec, 5198 Rt. 130, Bordentown,
NJ 08505. Postage due and freight collect
items will not be accepted.
Intrinsically Safe Apparatus
Princeton Tec League for use in hazardous
locations only as to intrinsic safety classes
I, II, III; Divisions 1&2; Groups A-G;
Temp Code: -20C to 40C (T4). Warning-
substitution of components may impair safety.
Change batteries in an area known to be
non-hazardous. Do not mix new batteries
with used, do not mix batteries from different
manufacturers. Use with three AA batteries,
UL 913
2011/09/23 UL
CAN/CSA C22.2#157
DAMAGES ARE
ISSUED:1992/06/01 ED:3 (R2012)
Conforms to UL 913 Eighth Edition,
Dated December 6, 2013.
Certified
No.157-92 June 2003.
Princeton Tec
PO Box 8057,
Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
www.princetontec.com
© 2015 Princeton Tec
Batteriewechsel
6
Schalterbetätigung
HIGH 10 H
75 130
ISSUE:2006/07/31 ED:7 REV:
to CAN/CSA-C22.2