Princeton Tec LPHL-1 Mode D'emploi

ENGLISH:
Switch Operation – See Figure 1
LPHL -1 is activated by pressing the button at the
top of the lamp.
LPHL -1 begins operation at high output level;
holding the button down will dim light output.
If more than two seconds have passed since
the previous button press, the next press will
turn the light off.
Battery Installation – See Figure 2
• Alkaline (LR03)
3 AAA
• Rechargeable NiCad or NiMH
NOTE: NiCad or NiMH batteries may result in
reduced brightness due to lower nominal voltage.
Princeton Tec cares about the environment and
recommends recycling batteries. For more
information about battery recycling, please go
to: www.batteryrecycling.com.
Observe proper battery polarity when installing
the batteries. Improper installation of the
batteries will damage the light and void the
warranty. The LPHL-1 battery compartment
has a water resistant seal. It is important to
keep this seal free from dirt and away from
harsh chemicals in order to preserve water
resistance. Inspect the seal every time batteries
are changed. If dirt is present, wipe gently with
a damp cotton swab and mild soap until dirt is
removed.
!
WARNING
• Never mix fresh and used batteries.
• Never mix different battery brands or
chemistry types.
• Always remove drained batteries immediately.
• Remove batteries during long periods of
storage.
NOTE: Some battery types can emit hydrogen
gas, which can create an explosion potential in
sealed devices if it is not vented or removed.
The LPHL-1 is equipped with a platinum catalyst
to remove this gas. Upon severe impact, the
catalyst could fracture. If you notice a rattling
sound in the headlamp or gray particles in the
battery compartment, do not use the headlamp.
See the warranty and return policy for more
information.
Troubleshooting
If the LPHL-1 fails to light:
• Check the batteries for proper installation.
• Replace batteries if proper
is confirmed.
• Check circuit board for water (the seal may
Figure 1 - Switch Operation
• Princeton Tec calculates total burn time as the time it takes for the light source to produce a minimum of
0.25 lux at 2 meters. 0.25 lux is about the equivalent of a full moon on a clear night.
• Princeton Tec berechnet die Gesamtbrenndauer bezogen auf eine von der Stirnlampe erzeugte
minimale Beleuchtungsstärke von 0,25 Lux in 2 Meter Abstand. 0,25 Lux entsprechen in etwa der
Beleuchtungsstärke des Vollmonds in einer klaren Nacht.
• Princeton Tec définit la durée totale d'éclairage comme le temps nécessaire à la source lumineuse pour
produire un minimum de 0,25 lux à 2 mètres. 0,25 lux équivaut à peu près à la luminosité d'une pleine
lune dans un ciel nocturne dégagé.
Figure 2 – Battery Replacement
1
Use tool on headstrap to open battery compartment
Utilisez l'outil attaché à la sangle de la frontale pour
ouvrir le compartiment des piles.
Verwenden Sie zum Öffnen des Batteriefachs das
am Kopfband befestigte Werkzeug.
3
have been compromised by improper rear
cover installation).
• The light will resume normal operation once
the water is shaken or blown out and the
light is left open until completely dry. If the
light has been contaminated with salt water,
flush the unit with fresh water and dry as
described above.
3-Year Warranty Princeton Tec offers a
3-year warranty on this product.
FULL WARRANTY – Princeton Tec warrants this
product to be free from defects in workmanship
and materials under normal use up to 3 years.
This warranty covers all of the component parts
of the product except batteries. This warranty
does not cover deterioration due to normal
wear or damage due to misuse, alteration,
negligence, accidents, or unauthorized repair.
Princeton Tec will repair or replace parts which
are defective in workmanship or materials.
Your authorized Princeton Tec Dealer and
Princeton Tec are the only facilities authorized
to repair the product. After (3) unsuccessful
attempts to repair the product, you have the
right to elect replacement of the product or a
refund of the purchase price less allowance
for use of the product. NO INCIDENTAL OR
CONSEQUENTIAL DAMAGES ARE INCLUDED
IN THIS WARRANTY. (Some states do not
allow the exclusion or limitation of incidental
or consequential damages, so the above
limitations or exclusions may not apply to you.)
installation
This warranty gives you specific legal rights, and
you may also have other rights which vary from
state to state.
Modes de fonctionnement
WHITE DIMMABLE
F L O O D H I G H Total 25 H
F L O O D L O W
Total 120 H
DISTANCE
0 1
(METERS)
Remplacement des piles
2
4
Princeton Tec reserves the right to change
product specifications without notice.
Return Policy
If your light fails to operate, follow these
simple steps:
1. Check batteries. Replace if necessary.
2. To send your light in for repair or replacement,
first contact Princeton Tec customer service
on 1-800-257-9080 to request an RMA
number. Please have your light model, date
of purchase and a brief description of the fault
you are experiencing. No warranty repairs
will be accepted without an RMA number.
3. Return the light without batteries to:
Princeton Tec, PO Box 8057 Trenton NJ
08650. Postage due and freight collect items
will not be accepted.
4. Upon receipt your light will be processed in
about two weeks. Please allow additional
time for return transportation from NJ.
Princeton Tec
PO Box 8057
Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
www.princetontec.com
© 2017 Princeton Tec
Schalterbetätigung
BEAM DISTANCE
14 m 13 m 3 m
1 m 1 m 1 m
7 0 H 0.5 H 10 H
14
Time
Batteriewechsel