Publicité
Les langues disponibles
Les langues disponibles
EN
Dear Customer,
We are delighted that you have chosen this air compressor.
Before using the device for the fi rst time, please read the instruc-
tions carefully and keep them for future reference. If the device is
given to someone else, these instructions should also be handed
over with it. If you have any questions, contact the customer ser-
vice department via our website:
www.service-shopping.de
Explanation of Symbols
Protection class III
Read operating instructions before use!
Circuit symbol for DC voltage
Intended Use
•
This air compressor is used to fi ll tyres, tubes, balls, air mat-
tresses etc. with air.
•
CAUTION! The display only shows approximate values. Check
the compressed air in car tyres using a professional air pres-
sure gauge.
•
The device should only be used as described in these instruc-
tions. Any other use is deemed to be improper.
•
The device is for personal use only and is not intended for com-
mercial applications.
•
The following are excluded from the warranty: all defects caused
by improper handling, damage or unauthorised attempts at re-
pair. This also applies to normal wear and tear.
Safety Instructions
■
Danger of suffocation! Keep children and animals away from
the device, the mains cable and packaging material.
■
The device is not a toy.
■
Danger of injury! Never breathe in the air which emerges from
the compressor, never place the valve connector / compressed
air tube in your mouth, nose or other orifi ces.
■
Before using the device, ensure that the power socket in
the vehicle is designed for min. 10 A and if possible that no
other consumers are in operation to prevent any overloading
of the circuit.
■
Keep the device, the mains cable and the plug away from water
or other liquids in order to avoid electric shocks.
■
Danger of bursting! Do not overfi ll objects! Find out the maxi-
mum pressure before pumping anything up and set this on the
device.
■
Check the device for damage before putting it into operation. If
the device, the mains cable or the plug shows visible signs of
damage, the device must not be used. Do not use the device if
it has malfunctioned or been dropped in water.
■
Do not make any modifi cations to the device. Have the repairs
performed only in a specialist workshop. In the event of any
damage, please contact our customer service department.
■
Do not use the device if fl ammable substances are present in
the air.
■
This device will become hot during use! Flammable objects in
the immediate vicinity of the device could ignite! The device
may neither come into contact with combustible materials, nor
be used close to combustible materials such as cardboard or
paper.
■
Ensure prior to each use that the ventilation slots of the device
are clear.
■
Unwind the mains cable fully before connecting up the device.
■
Make sure that the connected mains cable does not present
a trip hazard, is not squashed (trapped in a door) or bent, and
03470_de-en-fr-nl_A4_V1.indb 3
03470_de-en-fr-nl_A4_V1.indb 3
Article number 03470
does not come into contact with sharp edges or hot surfaces
(also of the device).
■
To ensure that the motor of the device does not overheat,
switch it off for at least 15 minutes after a maximum of 5
minutes of constant operation.
■
The device must always be disconnected from the mains power
when it is left unattended and before assembling, disassem-
bling or cleaning the device.
■
Allow the device to cool down completely before storing it away.
■
Do not drop the device or subject it to any impacts.
■
Do not expose the device to extreme temperatures (over 50°C
or sub-zero temperatures), wide temperature fl uctuations,
naked fl ames, direct sunlight, moisture or wet conditions.
■
Use only original spare parts from the manufacturer.
■
Do not use any corrosive or abrasive cleaning agents to clean
the device. These could damage the surface. Wipe down the
device with a soft damp cloth if necessary.
Items Supplied and Device Overview
6
1 LED
2 Valve connector
3 On-switch lock
off
4 On switch
5 Grip
6 Socket
7 Compressed air tube
8 LED On/Off button
9 Display
Use
2.
2.
Instructions
1
2
7
3
4
8
5
9
10
+
UNIT
11
10 Setting buttons:
UNIT choose unit: psi, bar,
kPa, kg / cm
on,
+ / – increase / reduce target
air pressure
11 Adapter compartment
12 Mains cable with vehicle
plug
13, 14 Adapter (e.g. for balls)
1. If one of the two adapters (13, 14)
1.
is required, press down the closure
of the adapter compartment (11)
and fl ip open the lid. Take out the
adapter.
2. Flip up the lever of the valve connec-
tor (2), insert the adapter (13, 14)
and then fl ip the lever down again.
1.
3. Connect the mains cable (12) to the
socket (6) of the compressor and the
vehicle plug to the cigarette lighter in
the vehicle. CAUTION: Make sure
that it is designed for min. 10 A!
Do not trap the mains cable (12) in
the door!
12
13
14
2
19.05.2017 10:32:28
19.05.2017 10:32:28
Publicité
