Télécharger Imprimer la page

Publicité

Liens rapides

ENGLISH
Battery Installation
See Battery Installation Diagram
• Tec-1: (1) CR123
• Tec-2: (2) CR123
Princeton Tec cares about the environment and recom-
mends recycling batteries. For more information about
battery recycling, please go to: www.batteryrecycling.com.
WARNING !
Never mix fresh and used batteries.
Never mix different battery brands or chemistry types.
Always remove drained batteries immediately.
Remove batteries during long periods of storage.
Low Profile Clip (optional)
Tec-1 and Tec-2 lights are assembled with pocket clip
installed at our factory. Pocket clip can be removed
and replaced with the included washer if desired, for
use with a weapon mount for instance.
O-Ring - Occasionally clean and lightly lubricate the
o-rings, lens cap and tail cap threads. Use only silicone
grease, never aerosol spray lubricants.
WARNING !
Certain forms of aerosol sprays can cause damage this
light's plastic components and void warranty.
FOR CALIFORNIA RESIDENTS: WARNING: This product
contains Bisphenol A (BpA) a chemical known to the
State of California to cause birth defects or other
reproductive harm.
TEC-1 & TEC-2
FLASHLIGHTS
Operating and Maintenance
Bedienungsanleitung
Notice d'utilisation et d'entretien
Troubleshooting
If the Tec-1/Tec-2 fails to light:
• Check the battery/batteries for proper installation.
• If proper installation is confirmed, replace battery/batteries.
• Check the inside of the light for water (the seal may
have been compromised). The light will resume
normal operation once the water is shaken or blown
out and the light is left open until completely dry. If
the light has been contaminated with salt water, flush
the unit with fresh water and dry as described above.
USA Limited Lifetime Warranty - International 10-year Warranty
Princeton Tec reserves the right to change product
specifications without notice.
Return Policy
If your light fails to operate, follow these simple steps:
1. Check batteries. Replace if necessary.
2. To send your light in for repair or replacement, first
contact Princeton Tec customer service on
1-800-257-9080 to request an RMA number. Please
have your light model, date of purchase and a
brief description of the fault you are experiencing.
No warranty repairs will be accepted without an
RMA number.
3. Return the light without batteries to: Princeton Tec,
PO Box 8057 Trenton NJ 08650. Postage due and
freight collect items will not be accepted.
4. Upon receipt your light will be processed in about
two weeks. Please allow additional time for return
transportation from NJ.
PO Box 8057
Trenton, NJ 08650 U.S.A
Tel.: 609-298-9331
www.princetontec.com
Fax: 609-298-9601
© 2018 Princeton Tec
Battery Installation
0218
Switch Operation
Tap or Press & Hold = momentary on
Double Tap = steady on;
next tap = off
Appuyer ou appuyer en continu =
allumage momentané
Appuyer deux fois = allumage permanent
appuyer une nouvelle fois = arrêt
Tippen oder gedrückt halten = kurz
einschalten
Doppelt tippen = dauerhaft einschalten;
nochmals tippen = aus

Publicité

loading

Sommaire des Matières pour Princeton Tec TEC-1

  • Page 1 If your light fails to operate, follow these simple steps: Low Profile Clip (optional) 1. Check batteries. Replace if necessary. Tec-1 and Tec-2 lights are assembled with pocket clip 2. To send your light in for repair or replacement, first installed at our factory. Pocket clip can be removed...
  • Page 2 Voir le schéma d’installation des piles un numéro d’autorisation de retour d’article Bestimmte Arten von Aerosolsprays können die Kunst- • Tec-1 :(1) CR123 • T2 :(2) CR123 afin de renvoyer votre lampe pour réparation ou stoffteile der Lampe beschädigen und zum Erlöschen Chez Princeton Tec, nous nous préoccupons de l’envi-...

Ce manuel est également adapté pour:

Tec-2