Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Changing remote control
The CLASSIC PREAMP comes with the RCU III remote control (see
page 42). This remote control uses standard RC5 codes from
Philips. It is called RC5 in the menu.
However, you may also use it with the Nagra RCU or RCU II remote
control (supplied with the Nagra CD range).
In this case, you should change the device number here:
Remote
RC5
« RC5 » displays, rotate the knob to select the remote control you
want the CLASSIC PREAMP to be controlled with i.e. Device 1, etc...
Then press once to validate your choice.
About
About
Soft V.
advise your dealer and also notify it on our website.
Op. Time
TubeTime
S.Number
r
In
the
menu,
« Remote » displays then press it once to
enter remote control selection.
Remote
This part of the menu will provide you with
useful
information
PREAMP.
Software
version:
CLASSIC
INT
Should we release a new version, we will
Operation time: this counter will let you know
how many hours the CLASSIC INT has been
powered on. It cannot be reset.
Tube time: this counter will let you know how
many hours the tubes have been running. It
can be reset when you change the tubes.
Serial number: this serial number cannot be
changed or erased. In the very unfortunate
event that your CLASSIC INT be stolen,
39
NAGRA – CLASSIC PREAMP
rotate
the
DEVICE 1
about
your
you
can
internal
software
knob
until
CLASSIC
check
the
version.
Publicité
Table des Matières
