Your Product At A Glance - Lux Tools 118 065 Mode D'emploi

Le compresseur avec manomètre pour gonflage de pneus est destiné au gonflage des pneus

Masquer les pouces

Table des Matières

Les langues disponibles

Reifenfuellmessgeraet_118065.book Seite 17 Dienstag, 12. April 2016 12:19 12

• Blow through or clean connections

before using for the first time. Soiling can

impair the function and and safety of the

product.

• Disconnect the product from the com-

pressed air supply during breaks in work,

prolonged periods of non-use or taking

out of operation.

• The product may only be connected to

lines that have a protection mechanism to

prevent the maximum permissible pres-

sure from being exceeded by more than

10%. This can be achieved, for example,

by a pressure regulating valve with a

downstream or built-in pressure limiting

valve being fitted into the compressed air

line.

• Only operate the product at the pressure

required for the operation concerned, in

order to prevent unnecessarily high noise

levels, excessive wear and the resultant

malfunctions.

• Compressed air can be dangerous if the

operator is unsure how it should be han-

dled. Assembly, commissioning and

maintenance is reserved for trained and

experienced persons.

• Do not direct compressed air at yourself

or at others in order to clean clothing and

footwear.

• Never blast objects that contain hazard-

ous substances (e.g. asbestos).

• Never use solvent-based liquids, ace-

tone, undiluted acids or solvents as

cleaning agents! A spray mist from these

substances is highly hazardous to health

and possibly explosive.

• Live components in the work area must

be protected from dirt and dust particles

being blown around.

• Only use compressed air. Never use air

containing chemicals, synthetic oils

(organic solvents), salts or corrosive gas,

as it can cause damage and malfunc-

tions.

• Use only lubricants recommended by the

manufacturer.

• Compressed air products are not

earthed. Proceed with caution when

coming into contact with power sources.

• Always attach protective caps when

transporting or storing products and

accessories.

Maintenance

• Interrupt, vent and depressurise all con-

nections before commencing any work

on the product.

• Only those maintenance and fault elimi-

nation tasks described here may be car-

ried out. Any other tasks must be com-

pleted by a specialist.

• Only use original replacement parts. Only

these replacement parts are designed

and suitable for the device. Other

replacement parts will not only lead to an

invalidation of the warranty, they may

also endanger you and your environment.

Device-specific safety instructions

• Make sure that the work area is well ven-

tilated.

• Make sure there is adequate lighting

when working with the product.

• Always maintain a firm stance and have a

natural posture when working.

• The on-off switch must be released if the

power supply fails, in order to prevent an

abrupt start-up when the power supply is

restored.

• Never insert tips and/or metallic objects

into the product.

• The container may burst, when filled with

the pressure exceeding the maximum

limit allowed by the manufacturer, this in

return may result in severe injuries and

death!

• Symbols appearing on your product may

not be removed or covered. Information

notices on the product that are no longer

legible must be replaced immediately.

Read and observe the operating in-

structions before commissioning.