Publicité
Les langues disponibles
Les langues disponibles
UNPACKING
This product requires assembly.
Carefully remove the product and any accessories from the box.
Make sure that all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage or damage
occurred during shipping.
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
PACKING LIST
−
Cutting Head
−
Pole Assembly
−
Rear Handle
−
Blade Cover
−
Hex Key
−
Instruction Manual
−
WARNING: If any parts are damaged or missing, do not operate
this product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
If any parts are damaged or missing, please call customer service
at 1-800-618-7474 for assistance.
POLE AND CUT HEAD ASSEMBLY
1.
Loosen the shaft coupling A by turning it counter-clockwise
and pull out the extension pole to the desired length. Tighten
the shaft coupling A by turning it clockwise.
2.
Loosen the shaft coupling B by turning it counter-clockwise.
3.
Align the arrow on the cutting head with the protruded lock pin
on the shaft.
4.
Insert the pole into the cutting head until the pin locks in place.
5.
Tighten the shaft coupling B by turning it clockwise.
ASSEMBLY
B
A
B
A
B
A
Model PS45010S
POLE AND HANDLE ASSEMBLY
1.
Loosen the shaft coupling A by turning it counter-clockwise and
pull out the extension pole to the desired length. Tighten the
shaft coupling A by turning it clockwise.
2.
Loosen the shaft coupling B by turning it counter-clockwise.
3.
Align the arrow on the handle with the protruded lock pin on the
shaft.
4.
Insert the pole into the handle until the pin locks in place.
5.
Tighten the shaft coupling B by turning it clockwise.
DIS-ASSEMBLE POLE AND CUTTING HEAD/HANDLE
To disassemble pole and cutting head or handle,
1.
Loosen the shaft coupling by turning it counter-clockwise;
2.
Use a small nail to depress the lock pin in the slot;
3.
Pull them apart.
ADJUSTING THE LENGTH OF THE TELESCOPIC POLE
1. To adjust the telescopic pole, disconnect the product from
the power supply. Rotate the shaft coupling counterclockwise
to loosen. Extend the pole to
the desired length.
NOTE: Only extend the pole to
minimum length required to reach
the limb or shrub to be cut.
2.
Lock the pole in position by
turning the shaft coupling
clockwise firmly to secure.
WARNING: Failure to lock the
telescopic pole coupling as
directed could result in personal
injury.
5
A
B
A
B
A
B
Publicité
