Operating Peripheral Equipment; Programming The Remote Control Code - HP Pavilion PL5000N Mode D'emploi

Operating Peripheral Equipment

Programming the remote
control code
Your HP remote control is programmable. You can
program the remote control to operate other home
entertainment devices such as your VCR, DVD player,
audio receiver, or set-top box. Manufacturer codes for
compatible brands are listed at the end of this chapter.
If the brand of your device is not listed, see "Searching
for the device code" on page 69.
Programming the device code
The following steps describe how to program a device
button if your brand is listed.
1
Turn on the TV. Turn on the device you would like
to program.
n
Read steps 2 through 4 completely before
proceeding. Highlight or write down the
codes and device you wish to program
before performing step 2.
2
Hold down a device button on the remote control
for 5 seconds until the device button blinks, and
then release the device button. The device button
blinks one more time and then remains lit.
3
Locate the brand of your device and manufacturer
codes (see the listing that follows).
4
Enter the first four-digit code. If the code is
accepted, the device button flashes twice. If the
code is not accepted, the device button flashes
three times.
n
If the device button did not blink twice,
repeat steps 2 through 4, entering either
the same code or the next code if provided.
5
Aim the remote control at the device, and press
the Power button once. The device should turn off.
If it does not respond, repeat steps 2 through 4,
trying each code for your brand until you find one
that works. If it still does not work, try searching
for the code; see "Searching for the device code"
on page 69.
n
If the device does not have a Power button,
press Play.
6
Repeat steps 1 through 5 for each device you
want to control with the remote control.
Searching for the device code
If your device does not respond to the remote control
after trying all codes listed for your brand, or if your
brand is not listed at all, try searching for your code.
1
Turn on your home entertainment device.
2
Hold down a device button on the remote control
for 5 seconds until the device button blinks, and
then release the device button. The device button
blinks one more time and then remains lit.
3
Enter 1, 1, 1, 1, and the device button blinks once
and then remains lit.
Operating Peripheral Equipment
69