wigam FINDER Notice D'utilisation page 9

1. TURN ON: Press the ON/OFF button once to turn on and again to turn off. NOTE: Hold button down for
approximately 1 second to turn unit off.
2. WARM UP: The detector automatically starts heating the sensor. During the heating cycle, the digital
leak size indicator will flash 0 and the detector will sound a slow "beep". Warm up is usually less than 20
seconds.
3. READY: The detector is ready to begin searching for leaks when the flashing 0 stops and the green
sensitivity LED turns on. The audio "beep" increases in frequency and probe LED begins to blink
steadily.
4. SEARCH: Move the probe tip towards a suspected refrigerant leak at the rate of less than 50 mm per
seconds, no more than 5 mm away from the suspected source.
5. DETECTION: If a leak exists, the sound will increase in rate and pitch and the display will show the
numerical indication of the leak size.
NOTE: the leak detector responds to changes in refrigerant concentration. When detection occurs, move the
probe away from the source and back again to confirm the leak source. The detector alarm will reset if the
probe is held fixed at the source (see Automatic Calibration Feature).
Version 2.0
FINDER Control Panel
Digital Leak Size
------ Indicator
A
__ Low Battery
Indicator
--- Sensitivity Level Indicators
*
Audio Mute &Sensitivity
Level Selectors
◄ Power
On/Off
Operating Instructions
9
FINDER
ENGLISH