Ramiaudio AMC800 Manuel Utilisateur page 14

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FRONT PANEL
1 - Switch to select monitoring of AES channel 1/2.
2 - Switch to select the solo key of the channel 2. This selection is active only having activated 1/2.
3 - Led of the audio modulation of the channel 2. The led will indicate if the modulation is available
in the channel 2, even if the 1/2 key is not selected.
4 - Switch to select the solo key of the channel 1. This selection is active only having activated
the1/2 key.
5 - Led of the audio modulation of the channel 1. The led will indicate if the modulation is available
in the channel 1, even if the 1/2 key is not selected.
6 - Same functions for the channel 3/4 as above for the channel 1/2.
7 - Same functions for the channel 5/6 as above for the channel 1/2.
8 - Same functions for the channel 7/8 as above for the channel 1/2.
The 8 modulation Leds are active while the corresponding channels are not selected.
9 - The leds 1/2, 3/4, 5/6 and 7/8 indicate the channel displayed by the peakmeter. Only one
channel is displayed even if the mixing of several channels AES.
10 - Channel A (left) peakmeter: -40 dB to 0dBFs (channels 1, 3, 5 or 7 according to the selection).
11 - Channel B (right) peakmeter: -40 dB to 0dBFs (channels 2, 4, 6 or 8 according to the selection).
The functioning of these switchs, the function of mixing and the peakmeter is described below
for more clarity.
12 - Volume control of the monitor output.
13 - Mute of the monitor output. This switch allows an interruption of the output signal
without retouch the volume 12. This switch has no effect on the headphone output.
14 - Volume control of the headphone output.
15 - Stereo jack for headphone connection.
Rami
14
Next
AMC800

Publicité

Chapitres

Table des Matières
loading

Table des Matières