Publicité
Les langues disponibles
Les langues disponibles
The headup display must be adjusted to the original speedometer in order to combine the two display
devices and achieve a homogeneous display.
1.
Start your vehicle.
1.
Press the button MODE to switch the display to the RPM display mode.
2.
Drive your vehicle at a constant speed to achieve 3,000 RPM.
3.
Simultaneously press the buttons DOWN & UP. The device stores the RPM adjustment.
4.
Stop your vehicle, switch off your ignition, and restart your vehicle.
This completes your RPM adjustment.
When performing the RPM adjustment, pay attention to
!
the road traffic and abide by the road traffic regulations.
When exceeding 2 selectable speed settings (L and H), the system can provide you with an optical and acoustic speed
warning, in particular a short flashing of the display and a warning tone.
1. Setting up speed warning function L
Press the button DOWN for at least 2 seconds to store the L-value
indicated on the display as warning speed. The system can only store
speed settings between 30 and 230 km/h.
If you press the button DOWN, and an L is displayed on your screen, then the speed warning function is deactivated.
If an L is displayed in combination with a number on your screen, e.g. L 30, then the speed warning function is activated.
L30
Speed warning function Low is
activated
14
RPM Adjustment
Speed Warning Functions
SET
MODE
L
Speed warning function Low is
deactivated
DOWN
UP
Publicité
