Télécharger Imprimer la page

INPRO Headup Display 5150 Instructions De Montage page 13

Publicité

Les langues disponibles

Les langues disponibles

1.
At the location where the film is to be applied, clean the screen by means of a suitable cleaning agent and
a soft lint-free cloth.
2.
Apply the reflective film as stated in a vertical manner within the described points. Moisten the position on
the screen and the film with distilled and/or deminera lised water by means of a spray bottle and a fine spray
nozzle. Remove the protective layer and carefully position the film. You can correct the placement as long as
there is water left between the film and the screen. To finalise the placement, use a squeegee or a lint-free
cloth to slowly move the water from the center of the film to the outside.
3.
Affix the display with the appropriate angle bracket in such a manner that you can clearly see the reflection
on the film from your seat. Minor adjustments can be achieved by simply adjusting the display on the angle
bracket.
SET:
MODE:
DOWN:
UP:
The headup display must be adjusted to the original speedometer in order to combine the two display
devices and achieve a homogeneous display.
1.
Start your vehicle.
Press the button MODE to switch the display to the speed display mode.
1.
2.
Drive your vehicle at a constant speed of 60 km/h.
3.
Simultaneously press the buttons DOWN & UP. The device stores the speedometer adjustment.
4.
Stop your vehicle, switch off your ignition, and restart your vehicle.
This completes your speedometer adjustment.
When performing the speedometer adjustment, pay attention
!
to the road traffic and abide by the road traffic regulations.
Control Electronics
SET
MODE
For dimming the display
Switches the display between speed and RPM at the touch of a button
Button for programme setup and adjustment.
Press the button for at least 2 seconds to open the low speed setup. Use the button DOWN
to set the value to "L".
Button for programme setup and adjustment.
Press the button for at least 2 seconds to open the high speed setup. Use the button UP to
set the value to "H".
Speedometer Adjustment
DOWN
UP
13

Publicité

loading