Adjusting Depth Of Cut - Freud FT1700VCE Notice Technique

Fig. 2e
WARNING: Failure to disengage the spindle lock or remove the wrench before operating this
power tool could result in injury or damage to the tool.
ADJUSTING DEPTH OF CUT (2 OPTIONS)
WARNING! Disconnect tool from power source.
Option 1 – Hand Held Use
a. Open the base clamp (O). - Fig. 3a
b. Turn the Micro Adjusting Knob until the bit
contacts the work surface making sure that
the router is level and flat. - Fig. 3b
c. Turn the Micro Adjustment Knob (B) clockwise to
the desired depth. (one complete rotation
varies the bit depth by 1/8").
d. Lock the base clamp (O) prior to operation.
English
Fig. 2f
12
Fig. 2g
Fig. 3a
Fig. 3b