Base Plate Angle Adjustment - Freud FJ85 Instructions D'utilisation

Setting 0 Good for metals, plastics, and best quality finish in wood and wood products
such as plywood, chip board, etc. Also good for scroll work.
Setting 1 Better quality cut in wood and wood products where speed of cut is more
imortant than quality of cut.
Setting 2 Good quality with faster cut speed in wood and wood products.
Setting 3 Fastest speed with coarse cuts in wood and wood products where speed is
more important than quality of cut.

7. Base Plate Angle Adjustment

The base plate may be tilted to produce angle
cuts up to 45º - Fig. 10.
To adjust the base plate, unplug the tool then
loosen the screw on the bottom of the saw with
the included allen key – Fig. 11.
Position the base as far forward as possible to
provide for maximum blade inclination – Fig. 12.
Position the base at the desired cutting angle and
tighten the screw in the bottom of the saw – Fig. 13
& 14.
Note: The base should be placed as far forward
as possible to allow for unlimited saw blade
inclination.
Fig. 11
English
13
Fig. 10
Fig. 12