Electrical Diagram - Praxair MICROTIG 161 Mode D'emploi

4T (4 times) welding mode :
This 4T mode allows welding continuously without pressing the torch trigger resulting in convenience for the operator and also
perform manual Tig pulse welding.
B – Adjust welding current by means of welding current adjustment knob
C - Down-slope time - Crater filler - Adjust down-slope time in seconds from 0 to 10 seconds by means of downslope adjusting
knob.
D - Post gas - Adjust post gas time in seconds from 0 to 7 seconds. The gas will continue to flow after torch trigger release (TIG
2T) or torch trigger press (TIG 4T).
E - Start welding.

7. ELECTRICAL DIAGRAM

8