Important Safety Information - Textron Company GREENLEE G FG01 Serie Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT SAFETY INFORMATION

This symbol is used to call your attention to hazards
or unsafe practices which could result in an injury or
property damage. The signal word, defined below,
indicates the severity of the hazard. The message
after the signal word provides information for pre-
venting or avoiding the hazard.
Immediate hazards which, if not avoided, WILL result
in severe injury or death.
Hazards which, if not avoided, COULD result in
severe injury or death.
Hazards or unsafe practices which, if not avoided,
MAY result in injury or property damage.
• Read and understand all of the
instructions and safety information
in this manual before operating or
servicing this tool.
• Read and understand the instruc-
tion manual supplied with your
cable puller.
Failure to follow instructions and
safety information could result in
severe injury or death.
Wear eye protection when operating
this tool.
Failure to wear eye protection could
result in serious eye injury.
Greenlee / A Textron Company
SAFETY
ALERT
SYMBOL
FG01 G-Series Smart Pull
Drop hazard:
Wear foot protection when using this
tool.
Failure to observe this warning could
result in serious injury.
Electric shock hazard:
• Do not expose tool to rain or use in
wet or damp locations.
• Disconnect from power source
before servicing or dismantling the
tool.
• Unplug the tool when not in use.
Failure to observe this warning could
result in severe injury or death.
Make sure the switch is in the OFF position before
connecting this tool to a power source. Accidental
startup could result in serious injury.
Keep hands away from rope and
rollers. Rope can crush a hand.
Failure to observe this warning could
result in severe injury or death.
Do not pull anything other than the pulling rope
through the FG01. Metallic objects such as pulling
grips, clevises and wire rope will damage the rollers.
Failure to observe this precaution may result in
damage to the tool.
Service should be performed by manufacturer-
approved service center only.
Note: Keep all decals clean and legible, and replace
when necessary.
3
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070

Publicité

Chapitres

Table des Matières
loading

Table des Matières