Changing The Tines; Storage - Grizzly Tools EGT 1440 Traduction De La Notice D'utilisation Originale

GB
• Before each use, check the
equipment for obvious defects
such as lose, worn or damaged
parts. Check that all nuts, bolts
and screws are sitting firmly.
• Check covers and safety de-
vices for damage and check
that they are sitting correctly.
Replace them if necessary.
Wear protective gloves when
carrying out maintenance and
cleaning work on the tool to
avoid injury from cuts.
Always clean the tool thoroughly after
each use. Always keep the tool clean.
Do not use cleaning fluids or solvents.
• Remove any soil and dirt residues stuck
to the tines, driveshaft, tool surface and
vents with a brush or dry cloth.
• Spray or rub biodegradable oil into the
tines.
• Clean soiled grips with a damp cloth
We shall not be held responsible for any
damage caused in any of the following ways:
- Improper repair
- Use of non-original parts
- Use other than for the intended purpose

Changing the tines

The device is equipped with 2 rows of cut-
ting blades, totalling 6 cutting blades in all,
which are easy to change. Both rows of
cutting blades can be inserted as desired
on the left or right of the gears (see
Always change both tine pairs at
the same time to avoid damage to
the tool from imbalance.
76
Switch the tool off, unplug it and
wait for the tines to stop turning.
1. Place the equipment on the
ground with the wheels pointing
upwards.
2. Undo the hexagon screw (15a)
and self-locking nut (15b) on the
row of cutting blades (15).
3. Take off the cutting blades from
the drive shaft (22).
4. Clean the drive shaft with bio oil.
5. Push the new row of cutting
blades onto the drive shaft such
that the holes on the blade axis
are lined up with the holes on
the drive shaft.
6. Push the hexagon screw (15a)
through the hole and screw on a
new self-locking nut (included in
the delivery contents with a new
cutting blade).
The device can be operated with
either 4 or 6 cutting blades (see
"Spare Parts/Accessories").

Storage

• Leave the motor to cool down before
you put the tool into a closed space.
• Keep the tool clean, dry and out of the
reach of children.
• Do not wrap the equipment in plastic
bags as damp could form.
Release the tightening levers
(7+10) and fold the upper handle
21). (6) and centre handle (9) down-
wards so that the device takes up
less space.
The cables must not be jammed
when you do this.