Homa San.iQ plus C140 WA Manuel D'instructions Original page 22

Follow this procedure:
6.01 5.09
6.01
1.08
1. Remove cover 1.03
2. Loosen hose clamp 6:03 and pull it back to pressure
hose 4.01
3. Slide pressure hose from pressure connection 5.08
4. Loosen the hose clamp 6.01 on the pressure hose
4.01
5. Pull the vacuum hose 4.01 from pipe elbow 3.02
6. Loosen the two nuts 5.01
7 . Peel off the discharge nozzle 5.08 from the tank
8. Loosen the nut 5.04
9. Drag components 5.06, 5.05 and 5.07 about 20cm
from the grommet 5.00
10. Remove the snap ring circlip 5.11 with pliers from the
grommet 5.00
11. Pull the pump cable 37 completely through the grom-
met 5:00 into the interior of the container
12. Pull the grommet 5.00 from the container and place
these components on the opposite hole of the con-
tainer
13. Attach the grommet 5.00 with the nut 5.01 to the
container
14. Plug the pump cable 37 with the components 5.06,
5.05 and 5.07 through the grommet 5.00
15. Mount the circlip 5.11 in the grommet 5.00
16. Now, slide components 5.06, 5.05 and 5:07 against
circle 5.11
17 . The cable must be positioned so that cable tie 5.03
must rest against the inside of component 5.07
22 | ENGLISH
5.01
5.02
5.10 5.08
1.03
4.01
6.03
6.01
3.02
5.01
5.00 5.07
5.03
5.11
5.02
1.01
18. Tighten nut 5.04 firmly
19. Never push pressure port 5.08 on the right side of
the container
20. Attach the pressure port 5.08 with nut 5:01 to the
container
21. Shorten pressure hose 4.01 on the circumferential
mark (about 2cm from the 90° angle)
22. Plug the two hose clamps 6.01 and 6.03 on the pres-
sure hose 4.01
23. Insert the pressure hose 4.01 to elbow pipe 3.02
24. Plug the pointy end of the pressure hose 4.01 on the
discharge connection 5.08
25. Screw the two hose clamps 6.01 and 6.03 in tightly
26. Attach the lid back to container 1.03
5.04
5.05
37
5.06
5.05